Installation Instructions Tools Needed 5/16” Wrench or Nut Driver Flat Blade Screwdriver 1/4" Wrench or Nut Driver 7/16” Wrench or Ratchet Installation Procedure (Note: For better visibility in the attached pictures, the countertop was removed. If you wish to do this for your installation, there are four screws that attach the bottom of the countertop to the drawer frame.) Remove back panel from drawer.
strain relief the cable, snap the grommet into place, and then connect Heater Harness B. See Figures #5 & #6 Mount the heater power supply in a position so the switch is accessible, drill holes as necessary with the bit provided. If mounting the supply to the side of the drawer, check that the holes and screws will not damage or interfere with drawer operation, and secure with the #8x3/8”...