Advertisement

Operation &
Maintenance Manual
Spel Filter®
Cartridge Filter For Tertiary Stormwater Treatment
spel.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spel Filter and is the answer not in the manual?

Questions and answers

Summary of Contents for SPEL Spel Filter

  • Page 1 Operation & Maintenance Manual Spel Filter® Cartridge Filter For Tertiary Stormwater Treatment spel.com.au...
  • Page 2: Table Of Contents

    System Configuration ............7 Health and Safety ............. 8 Maintenance frequency ..........10 Maintenance Procedure ..........11 General Cleaning ............12 Cartridge Recycling and Replacement .....13 Standard Drawings ............14 Site Exit & Clean Up ............16 SPEL Stormwater Installation & Operation Manual | SPEL Filter...
  • Page 3: Introduction

    The filters can be housed in either a concrete or the SPELFilter product fibreglass structure that evenly distributes the flow between cartridges. Figure 1 - SPELFilters in a concrete chamber / vault visit www.spel.com.au for detailed data sheets on our products...
  • Page 4: Features

    SPEL Stormwater Installation & Operation Manual | SPEL Filter...
  • Page 5 SPELFilter from sediment buildup. It is for this reason that SPEL recommended the sediment buildup not exceed 150mm above the vault floor, so as to avoid blocking the inlet ports of the SPELFilter.
  • Page 6: Sizes

    Sizes SPEL Stormwater manufactures two height cartridges for varying site constraints as shown below. Each cartridge is designed to treat stormwater at a flow rate of 1.47 Litres per second and 2.83 Litres per second for the half- height cartridge (model No. SF.15-EMC-M) and full-height cartridge (model No. SF.30-EMC-M) respectively.
  • Page 7: System Configuration

    SPELFilter models. Typical SPELFilter system configurations are shown below. In-line SPELFilter Configuration Inlet Outlet Off-line SPELFilter Configuration Outlet Inlet visit www.spel.com.au for detailed data sheets on our products...
  • Page 8: Health And Safety

    D. Traffic Control • Ensure responsibility is accepted by all employees to practice and promote a safe and healthy work It is not uncommon for SPEL Filter cartridges to be environment. installed underneath trafficable areas. Minimum traffic control measures will need to be put in place in accordance with traffic control plans set out by B.
  • Page 9 products...
  • Page 10: Maintenance Frequency

    • Unforeseen environmental hazards affecting the SPELFilter functionality. • Accumulation of debris/pollutants on the outlet chamber of the SPELFilter vault; • After large storm events, tidal or flooding impacts at the request of the owner; SPEL Stormwater Installation & Operation Manual | SPEL Filter...
  • Page 11: Maintenance Procedure

    SPEL representative. Assemble and position the gantry above the manhole safely and as practically as possible. Attach the winch or chain block to the gantry for lifting the SPEL Filters. Perform safety procedures ie. Attach harnesses etc. (if confined space).
  • Page 12: General Cleaning

    Attach the winch 8. Reinstate SPELFilter system and disposal. or chain block to the gantry for lifting the SPEL Filters. At the completion of the site inspection, ensure the site Perform safety procedures ie. Attach harnesses etc. (if is reinstated back to its initial state and all pollutants confined space).
  • Page 13: Cartridge Recycling And Replacement

    Attach the winch or chain block to the gantry for lifting the SPEL Filters. Perform safety procedures ie. Attach harnesses etc. (if 8. Install pipework and SPEL Filters.
  • Page 14: Standard Drawings

    Standard Drawings - Full Height SPEL Stormwater Installation & Operation Manual | SPEL Filter...
  • Page 15 Standard Drawings - Half Height visit www.spel.com.au for detailed data sheets on our products...
  • Page 16: Site Exit & Clean Up

    Site Exit & Clean Up At the end of the scheduled maintenance, approved contractors or SPEL maintenance crew are required to reinstate the site to pre-existing conditions. Steps included but limited to are: • Ensure all access covers are securely inserted back into their frames;...
  • Page 17 Email: sales@spel.com.au spel.com.au SPEL Stormwater accepts no responsibility for any loss or damage resulting from any person acting on this information. The details and dimensions contained in this document may change, please check with SPEL Stormwater for confirmation of current specifications.

Table of Contents