Summary of Contents for CFW 80L
- Page 1 COMMERCIAL DEHUMIDIFIER MODEL: CFW 80L INSTRUCTION MANUAL SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE...
- Page 2 Packaging Please DO NOT dispose of any packaging until you have checked the appliance is operational. After removing the packaging ensure the contents are intact and complete. In the unlikely event of missing parts; contact your retailer. DO NOT leave children unattended with any of the packaging since it is a potential source of danger.
- Page 3 WARNING -to reduce the risk of fire, electrical shock or injury to persons or property: 1 Always operate the product from a power source of the same voltage, frequency and rating as indicated on the product identification plate. 2 Close supervision is necessary when any product is used by or near children the elderly or the infirm.
- Page 4 7 The use of attachments or accessories not recommended or sold by the product distributor may cause injury to persons or damage to property. 8 This product is intended for normal light commercial use only. 9 Do not attempt to dismantle the appliance. 10 Do not operate the appliance on a metal surface.
- Page 5 INSTRUCTIONS 1. Control Panel 6.Air Outlet 2. N/A 7. Power cord fixed support 3. Air Filter 8.Wheel 4. Air Intake metal grill 9.Power Cord 5. Handle 10.Water pipe - 4 -...
- Page 6 SETTING UP THE DEHUMIDIFIER WARNING No not obstruct the air intake or air outlet IMPORTANT Place dehumidifier in the upright position. When transporting a dehumidifier to site, allow the dehumidifier to stand for 30 minutes before switching ON. This is necessary to allow the refrigerant system to stabilize and avoid system damage.
- Page 7 Illustration of correct positioning for best performance PROPER AIR FLOW IS ESSENTIAL: Do not place this dehumidifier in a position where the front Air Intake Grill or rear Air Outlet is blocked by walls, furniture or any other obstruction. Do not attach ductwork to the unit as air flow restrictions will result.
-
Page 8: Plug In Electrical Cord
Front Air Intake Grill 3m. MAXIMUM Rear Drain DRAIN HEIGHT Hose Outlet ⚫ Plug in electrical cord This dehumidifier must be plugged into a grounded polarized 230 VAC/50Hz outlet rated at least 16 amps. Make sure the drain hose is connected and routed to a safe location. -
Page 9: Humidity Setting
⚫ Turn the unit OFF Press the “ON/OFF” to turn the unit OFF. When the unit turns OFF, The water pump will turn on automatically for 40 seconds to drain the residual condensate water in the dehumidifier. The screen will appear Draining…… IMPORTANT: To avoid water spillage. -
Page 10: Timer Off
TOTAL 99999h T1- Coil temperature TOTAL- Total running hour The menu will return to main menu if there is no other operation within next 5 secs. ⚫ Timer OFF When the dehumidifier is running ON, Press menu button twice to enter timer off, The screen will display : TIMER OFF Press down to setting the desired time between... -
Page 11: Cleaning The Air Filter
button thrice to enter calibration The screen will display : Set Target Set Point = This is only to set/calibrate the ambient humidity sensor. down to set the ambient humidity. ◆.Cleaning The Air Filter Ensure the dehumidifier is turned OFF and the plug is removed from the power socket before maintenance is carried out. -
Page 12: Maintenance
1. Remove the filter as shown in the diagram above. 2. Vacuum any debris from the filter using the vacuum hose and nozzle attachment. 3. Using luke-warm water and a mild detergent wash the filter and allow drying. 4. Once dry, re-install the filter into the dehumidifier Maintenance CLENAING THE WATER PUMP... - Page 13 Follow the guidelines below when storing the machine. 1. Wind the power cord to the back of the machine. 2. Wind the drainage tube to the back of the machine. 3. Stack the machines as shown if necessary. NOTICE: Do not stack more than two machines high.
- Page 14 FAULT CAUSE SOLUTION Unit does not No power to machine. Plug in unit; check power at operate Unit not switched on. outlet and at base of unit. Switch unit on. Fan not turning Obstructed air Remove obstruction. outlet and fan. - 13 -...
- Page 15 Unit operating, 1. Not enough time to 1. Allow more time for drying. but room not dehumidify air. 2. Increase air movement 2. Poor air movement with fans. in room. 3. Reduce outside air 3. Excessive moist air infiltration into the room. infiltration in room.
- Page 16 3.Replace sensor . 2. Check pump display panel 3.Replace display panel debris or blockage. Dehumidifying Capacity 80L/day (30° C RH80%): (170 pins/day) Dehumidifying Capacity 48L/day (26.7° C RH60%): (100 pins/day) Rating Power Input / Current 1450W/6.4A (30° C RH80%): Rating Power Input / Current 1150W/5.1A...
- Page 17 Power Supply: 220-240V ~ 50Hz Refrigerant: R410A/720g Working Temperature: 5° C~35° C Electronic Controls Touchpad Process Air 520m Unit Size(mm ): 540x540x810 Packing Size(mm): 580x580x850 Net/Gross Weight: 47kg/52kg - 16 -...