Advertisement
Quick Links
Note: This Bracket assembly replaces the regular Transom Bracket as referred to in the Smart Tabs manual and SX instructions.
Pr500 Plate Retractor
Substitution for the installation of the standard Transom Bracket:
With the PR 500 Handle in the "Down" position mark the location of the bracket mounting holes. Use the 25 degree Trim Plate
Template to locate the PR 500 Bracket position on the transom and mark the two mounting holes and two sides of the bracket
with a pencil as shown in picture step1. Cut the PR 500 Foot print Template from the instructions (Step2). Now align and tape
the template to the Transom(step3). Drill two 3/16"(for wood and aluminum) or 7/32" (for fiberglass) mounting hole as shown
on the template. Apply Marine sealant into the holes and mount the bracket using the 1/4" sheet metal screws provided.
ProTroller
Substitution for the installation of the standard Transom Bracket:
Replaces ST instruction Pg 6 #8 or SX instruction page 6 #9 : With the PR 500 Handle in the "UP" position it will be necessary
to mark the location of the bracket because the mounting holes will be blocked by the actuator. Use the 25 degree Trim Plate
Template to locate the PR 500 Bracket position on the transom and mark at least two sides of the bracket location with a
pencil as shown in picture Step1. Cut the PR 500 Foot print Template from the instruction (Step2). Now align and tape the
template to the Transom. (Step3) Drill two 3/16"(for wood and aluminum) or 7/32" (for fiberglass) mounting hole as shown on
the template. Apply Marine sealant into the holes and mount the bracket using the 1/4" sheet metal screws provided.
1.25"
PR500 Bracket
foot print template
Installation Supplement
(
ProTroller and PR500)
Assembly for this bracket on reverse side!
SMART TABS plates in the
RUNNING POSITION
Lever
DOWN
SMART TABS plates in the
RUNNING POSITION
Lever Up
Step1
Handle
Step2
Ph: 440-746-1290
Web: www.nauticusInc.com
SMART TABS plates in the
RETRACTED POSITION
Lever Up
SMART TABS plates in the
TROLLING POSITION
Lever
DOWN
Step3
Advertisement
Summary of Contents for Nauticus ProTroller
- Page 1 Installation Supplement ProTroller and PR500) Note: This Bracket assembly replaces the regular Transom Bracket as referred to in the Smart Tabs manual and SX instructions. Assembly for this bracket on reverse side! Pr500 Plate Retractor Substitution for the installation of the standard Transom Bracket: With the PR 500 Handle in the “Down”...
- Page 2 PR500 Bracket Assembly (Used in Smart Tabs ProTrollerSeries Kits and Plate Retractor Kits) www.nauticusinc.com Change out the Top end fitting by unscrewing Attach the lever arm to the Insure all the below hardware is in you kit from the actuator. You will only need to PR500 Bracket using the 5/16”phillips do this if you have the SX trim tabs.