Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MW POWER MW-SC4B
Summary of Contents for MW POWER MW-SC4B
- Page 1 BATTERY CHARGER INSTRUCTION MANUAL Model: MW-SC4B Please save these instructions. These instructions contain important safety and operating instructions. Read all instructions and follow them with each use of this product. MW-SC4B-manual-EN-R1, 22.06.2020...
-
Page 2: Table Of Contents
Figure 1: Product overview Contents Introduction Intended use Scope of delivery List of parts Technical data Safety Safety instructions Product description Operation Before use Connection Disconnection Mode selection Figure 2: Product overview Mode 1 - 6V (7.2V/1A) Mode 2 - 6V (7.4V/1A) Mode 3 - 12V (14.4V/1A) -
Page 3: Introduction
Introduction 6V charging mode in cold state, also for 10+11 many 6V AGM battery 6V charging mode 1A charging mode 4A charging mode The instructions contain important information 12V charging mode concerning safety, use and disposal. Before using 12V charging mode in cold state, also 14+15 the product, please carefully study with all of the for many 12V AGM battery... -
Page 4: Product Description
Do not use the battery charger in the The battery capacity ranges from 6V/1.2Ah to circumstances that the output polarity does 6V/14Ah or from 12V/1.2Ah to 12V/140Ah. not match the load polarity. If the supply cord is damaged, it must be The special design permits re-charging up to ... -
Page 5: Disconnection
Mode Selection the negative pole of the battery or to the car body. However well away from fuel pipes. Select the required mode by pressing the If connection is right and the battery is 8V mode selection button. above, battery voltage is correctly shown The following 6 modes are available. -
Page 6: Mode 3 - 12V (14.4V/1A)
taken, charging will automatically start after 3 seconds. During charging, the charge Press the mode selection button to select status display shows the progress of the mode 5. The symbol charge procedure (1 - 6 bars). When the shown on the LCD. If no further action is battery is fully charged, the charge status taken, then charging will automatically start display shows 6 bars. -
Page 7: Pulse Charge
Stage 1: Initialization charge. This pulse charge will finish after the Checks the battery's condition to determine the battery is above 5.3V for 6V modes or 10.5V for charge process. If the battery is deeply 12V modes. Meanwhile the max time for pulse discharged, it will enter into the pulse charge to charge is 30 minutes, and enters into normal refresh the battery. -
Page 8: Overheat Protection
domestic waste! the symbol is shown on the LCD. If maximum charge time has been European Directive 2012/19/EU requires that exceeded, the symbol in shown on worn-out products are collected separately and the LCD. fed into an environmentally compatible recycling process.
Need help?
Do you have a question about the MW-SC4B and is the answer not in the manual?
Questions and answers