Nomad Furniture Full Moon Assembly Instructions

Tools needed for assembly
A Phillips screwdriver
Rubber mallet or hammer w/block included
Optional: one friend
Bed parts list
2 short legs with shoulder screws
2 long bed legs-headboard
2 lower crosspieces with 3/16" drilled holes
crosspieces with no holes
1
2-wide curved crosspieces with ½" bored holes
2-side rails with ledgers
I -center support (2 for King size)
1 strapped slat roll
4-5/S"shoulder screws
2-1" screws (for slats)
Rubber bands
Extra Footboard Option:
Add 1 more crosspiece
With 2 longer legs
Headboard.Assembly
1. If possible, go to this site for photo slides of assembly
2. Identify all pieces before beginning. Lay out parts as shown in written instructions.
Note: To protect the wood only use a hammer with the wood block in shipping box as a pad, to tap down parts. Or a rubber mallet
works nicely with a baggie over the mallet (no black marks).
3. Attach drilled crosspiece to the bottom set of shoulder screws on one long leg and firmly tap down snug.
Note: When attaching crosspieces to shoulder screws on legs; the top shoulder screw should be located in the center of the
crosspiece. Refer to our "CAUTION SHEET" and use the alignment stick to assist with assembly.
4. Attach crosspiece to the second set of shoulder screws on the same long leg and tap down snug.
first
5. Prop up a bored crosspiece so holes are on top and connectors ends open up.
6. Insert dowels the crosspiece.
into
7. Hold the other bored crosspiece with the holes facing down over the dowels.
8. Starting at the right end, insert the
Illustration B.
Continue from right to left inserting one dowel at a time until all dowels are inserted. Slip second rubber bank over left end
9.
to bold the crosspieces, thus trapping the dowels.
10. Lay the parts down and use the 1 /2 " spacer to help align the unit to the leg. (see Caution Sheet) Connect unit to top set of
shoulder screws on the long leg. Tap top cross piece only until unit is snug.
Note: When connecting rails and crosspieces to legs, rail ends should be pushed down over pins.
Add lower crosspiece to the same leg and tap down snug.
I l.
Attach all the crosspieces simultaneously to t he other headboard leg using the ½" specer to help. Tap
12.
Note: It is important that all joints are tapped down completely.
1 3.
Cut rubber bands when completely connected.
Full Moon Bed Assembly Instructions
Dave Cady,s
Albuquerque, NM www.nomadfurniture.com 505-250-5231
·i- ---- ------------- -- - ----- �
lllustration A
NOMA DFURNITURE.COM/BED-ASSEMBL Y-GALLERY
dowel into the first hole. Slip rubber band over the right ends as shown in
first
NOMAD FURNITURE
0
/
snug.
down