Summary of Contents for Xane F38 HORNET
- Page 1 H O R N E T VERSION 1 Wingspan：800mm/31.5in Length：550mm/21.7in Flying weight：560g/19.8oz ASSEMBLY AND OPERATION INSTRUCTIONS MANUAL...
-
Page 2: Specifications
Ready-to-Fly version. If you have KIT version, this manual also will let you know how to assembly it and make the plane to Ready-to-Fly version. Please be sure to read the entire manual carefully prior to assembling/operating the F38 Hornet. Specifications... - Page 3 F-38 HORNET 1. Before assembling the model Please check the contents of your kit before you start working on it. You need : Servo-----2pcs Ÿ Motor------2830-1200KV and 8×6 propellers Ÿ ESC--------30A hobby wing Ÿ 2. Preparation Fig. 1 Main wing panel. Apply adhesive (not included) to the servo holes, and then located the servo into the hole.
- Page 4 F-38 HORNET Fig. 2 Main wing panel. Adjusting the Clevis Ÿ Turn the clevis (A) clockwise or counterclockwise on the linkage. Ÿ Carefully spread the clevis and put the clevis pin (B) in a selected hole in the control horn (C). Ÿ...
- Page 5 F-38 HORNET Fig. 3 Assembly the tail wing. Apply adhesive(not include) to the Vertical fin and then glued with fuselage. Ÿ Fig. 4 Assembly the propellers. -05-...
- Page 6 F-38 HORNET Fig. 5 Assembly the landing gear. Push the landing gear into the hole of the plastic set. Ÿ Then the plane were assembled finished. 3. Assembly the receiver and battery 3.1 Receiver installation The receiver has to be installed further aft in the fuselage. Check that the cables are long enough to Ÿ...
- Page 7 F-38 HORNET 3.2 Battery installation Install the battery in the model as below pic,and Ÿ fixed the battery with loop straps,this is very import,because this plane is an high performance Acro model,Loose battery maybe crashed the plane. Fig. 1 LiPo charging instructions Charge the LiPo battery by connecting the wall socket Ÿ...
- Page 8 F-38 HORNET 5. Checking the model’s balance. Place the flight battery in its compartment without connecting. Ÿ Mark the centre of gravity (CG) on both sides of the fuselage; the position is shown in the photo. Ÿ Support the model at the marked points and allow it to hang freely. When correctly balanced the Ÿ...