Advertisement
Quick Links
Assembly & User Instructions
Thank you for purchasing an Ace Innovation SuperVisor®
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING ASSEMBLY
Assembly Step 1 – Use the diagram below to help
1. Attach the supplied G-Clamp to a suitable stable surface and secure it tightly using
the integrated bolt. *WARNING* DO NOT attach the G-Clamp if you feel that it may
cause any damage to the surface you are mounting it on. If the G-Clamp is not
suitable you will need to contact your supplier and order the SuperVisor® weighted
base.
2. *WARNING* Care should be taken when unpacking the SuperVisor® Arm as it is
spring operated and unbalanced until the Visor element is installed [See Fig 2].
3. Once the G-Clamp or weighted base is secure, loosen off the lock nut [See Fig 1]
and lower the end of the SuperVisor® Arm into the top hole of the clamp or base.
Once the Arm is fully inserted, tighten the lock nut to secure it.
Fig 1
SuperVisor®
Assembly
www.aceinnovation.co.uk
08455 199181
Advertisement
Summary of Contents for Ace Innovation SuperVisor
- Page 1 3. Once the G-Clamp or weighted base is secure, loosen off the lock nut [See Fig 1] and lower the end of the SuperVisor® Arm into the top hole of the clamp or base. Once the Arm is fully inserted, tighten the lock nut to secure it.
- Page 2 Assembly Step 2 – Use the diagram below to help 1. Unscrew and remove ONLY the Upper Flange Nut from the SuperVisor® Arm. *WARNING* DO NOT attempt to unscrew the Lower Flange Nut as it has already been fixed in the correct position.
- Page 3 Adjustments Adjustments – Use the diagrams below to help The SuperVisor® is extremely versatile and can be adjusted in many different ways in order to meet your requirements. When adjusting the Angle and Tilt level of your Visor; to prevent damage please ONLY handle the Visor at the end which is connected to the Arm.
- Page 4 The Visor element of the SuperVisor® is made from a lightweight material which, during manufacture and general use, may acquire superficial marks and indentations. This does not affect the function, or impact on the operation of your SuperVisor® and is therefore not covered by the warranty.