Advertisement
Quick Links
ODME PRINTER UPGRADE INSTALLATION INSTRUCTIONS.
Dear Customer and or Colleague:
BEFORE YOU START THE PRINTER UPGRADE JOB PLEASE
READ CAREFULLY THE PRESENT INSTRUCTIONS:
At the end of the job you are kindly requested to send us a small e-mail message
at
technical@darlas.gr
We are wishing you GOOD LUCK...
Very Best Regards
Darlas Electronic Applications
Technical Department
5, Kimonos Str.,
122 44, Egaleo-Athens-Greece
Phones: +30-210-5986179, +30-210-5986213
Fax: +30-210-5911161
e-mail:
technical@darlas.gr
http://www.darlas.gr
ID
Part Number
1
S-ENRG054-P5
2
S-ENRG053-P5
Telephones: +30-210-5986179, +30-210-5986213, +30-210-5310551, +30-210-5310674, +30-210-5310775
Fax: +30-210-5911161, E-mail:
Established in Athens-Greece as a Societal Anonym (SA), Reg. No: 16494/01
Bankers: National Bank of Greece SA, Egaleo Branch (105), IBAN: GR16 0110 1050 0000 1054 7023 795.
DARLAS S-300-2
!!!...WARNING...!!!
letting us know the results of this project.
Consumables Part Numbers and Descriptions.
Description
RIBBON INK 5PCS ERC09 MK3 VER 2
PAPER ROLL EPSON 5PCS MK3 VER 2
5, Kimonos Str., 122 44 Egaleo – Athens – Greece.
sales@darlas.gr
,
technical@darlas.gr
Page 1 of 8.
Qty
Per
Pack
5
5
Internet:
http://www.darlas.gr
/B/88/343, Fully Paid Capital: € 58 694.06
Price
In €
PerPack
162.30
32.46
Advertisement
Summary of Contents for DARLAS S-300-2
- Page 1 DARLAS S-300-2 ODME PRINTER UPGRADE INSTALLATION INSTRUCTIONS. Dear Customer and or Colleague: !!!…WARNING…!!! BEFORE YOU START THE PRINTER UPGRADE JOB PLEASE READ CAREFULLY THE PRESENT INSTRUCTIONS: At the end of the job you are kindly requested to send us a small e-mail message technical@darlas.gr...
- Page 2 Prepare the new printer: Make sure that Megatron DIP switches are set as follows: (SW1-1 and SW1-2 OFF, all other ON) and (short circuit between J9-2 & J9-3) Use printer card interface DARLAS 300-2: TB 12 TB 01 Dismantle the three screws of the printer board, mount in their place the three thread extension rods supplied and then install the interface card on the top of these three thread extension rods.
- Page 3 DARLAS_300_2 ODME PRINTER INTERFACE DARLAS_300_2 MK- Page :3/8 Update for MK-I and MK-II Calculator II_R3_update.doc Connect the paper fault cable with cable facing outside of the printer side. Check the Dip Switch to make sure it is set in the Hengstler position. TDx to printer RTx from calculator Paper fault connector...
- Page 4 DARLAS_300_2 ODME PRINTER INTERFACE DARLAS_300_2 MK- Page :4/8 Update for MK-I and MK-II Calculator II_R3_update.doc Make mechanical adaptations on the Calculator Facial Panel, It’s necessary dismount completely the printer window, Hengstler printer and Hengstler paper roll. Paper roll Hengstler printer Printer window To replace the printer window it’s necessary use the mechanical plate H300_2_MEC01_MKII.
- Page 5 DARLAS_300_2 ODME PRINTER INTERFACE DARLAS_300_2 MK- Page :5/8 Update for MK-I and MK-II Calculator II_R3_update.doc Make on Calculator, some minor electronic modifications: The modification is very simple. On the Power Supply Regulation Board P/N: ES663-101, it’s necessary to short out the D23. The easiest way to do this is to do it on the solder side of the board.
- Page 6 DARLAS_300_2 ODME PRINTER INTERFACE DARLAS_300_2 MK- Page :6/8 Update for MK-I and MK-II Calculator II_R3_update.doc Realize the new cable: For the connection of Megatron printer, we use the set of cables supplied with your kit, which fit directly on the existing connectors: IA connector with 6 pins IB connector with 3 pins I connector HE10 with 16 pins...
-
Page 7: Replacing The Paper
age Page: 7 of 8. REPLACING THE PAPER : 1- For the MRS x2xx: tear off the rewinded paper first. 2- Unscrew the two unremovable screws (1 and 2). The panel ( 3 ), in front of the revolving door, can then be removed. 3- Open the revolving door ( 7 ) giving access inside the printer. -
Page 8: Replacing Of The Ink Cartridge
age Pa P ge: 8 of 8. REPLACING OF THE INK CARTRIDGE: 1- For the MRS x2xx: tear off the rewinded paper . 2- Unscrew the two unremovable screws (1 and 2). The panel ( 3 ), in front of the revolving door, can then be removed giving access to the ink cartridge ( 4 ).