RailFX 601 Series Installation Instructions

Kit 601 Series Installation Instructions

Tools Required for Installation

• 7/32" Drill Bit
• 5/32" Drill Bit
• 29/64" Drill Bit
• 3" Combo Wrench

A. Drill Posts

Hole size for 1/8" dia. cable installation
5/32"
dia.
29/64"
dia.
Hole size for end post using Push-Lock

B. Install Tensioning Terminal

1. Feed the bare cable through first end post, keeping some of
the cable with the swaging stud available so you can
perform the next step.
2. Slip the stainless steel washer over the body of the Receiver
and start the swaging stud into the Receiver and turn
3 complete turns. This will thread about 1/2 of the stud
into the Receiver.
3. Insert the Receiver with the stud into the post.
RFX-601-KITINST
for 4x4 Wood Posts
• Driver PL-LAG
• 3/16" Alllen Wrench
• RFXPL-KEY
• RailFX Cable Gripper
5/32"
dia.
29/64"
dia.
R-6-62 Receiver and stud
outside of post
Lag
®
7/32"
1½" minimum
dia.
outside of post
Pre-attached
swaging stud
Invisiware
Receiver
Hole size for 3/16" dia. cable installation
For Intermediate Post 7/32"
dia.
passing cable only
For End Post
29/64"
using a
dia.
S/S
Flat Washer
P: 206.453.1123 | F: 866.802.1690 | railfx.net
1/8" and 3/16"
1x19 stainless
steel cable
®
Stainless Steel washer
for use with wood post
601 Series
outside of post
Pre-attached Swaging Stud
Push-Lock
®
Lag
7/32"
dia.
29/64"
dia.
1.1.20 | 1