Page 2
Solflex GmbH Am Feuerstein 282 2392 Wienerwald Austria T: +43223820336 E: office@solflex.eu www.solflex.eu ATU 65324348 FN 337206t Always observe all relevant standards and statutory regulations Subject to change without prior notice. All business transactions based on our Terms and Conditions, available at www.solflex.eu...
Table of content General information ............4 Technical Data ..............4 Warranty ................ 5 Safety ................5 4.1. Intended use ..............5 4.2. Safety instructions ............5 4.2.1. Risks during unloading and transportation ......5 4.2.2. Risk of damage to property and the environment ....5 4.3.
1. General information Solflex produces SonaSafe acoustic housing for a wide range of Heat Pump, Air Conditioning and Refrigeration systems. This manual applies to the following series: SonaSafe HW* Serie 2. Technical Data Stable, insulated box body with a completely dismountable body.
3. Warranty 4.2.2. Risk of damage to property and the environment 24 months from delivery. 4. Safety In the event of improper operation or operation for a purpose other than the Serious damage to property from intended, there is however a risk of dropping loads;...
5.1. Unloading / transport to location of installation This unit is shipped in parts on a pallet. For unloading, lift the unit by the pallet. Too short forks can damage the acoustic housing. Risk of serious injury or damage to property from dropping loads.
Installation of unit At the place of installation, it must be possible to provide impeccable service and maintenance and the necessary air intake of the built-in air-conditioning, refrigeration and heat pump units. When planning the installation site, the guide lines for minimum distances around the air-conditioning, refrigeration and heat pump manufacturer must be respected.
6.2. Installation of Heat Pump, 7.2. Silencers Air Conditioning and The sound insulation material of the Refrigeration outdoor unit silencers should be checked for dust during major maintenance work and, if necessary, cleaned with a vacuum cleaner. The correct installation position of the air If necessary, the silencers must be conditioning, refrigeration or heat pump checked for free passage, as this is...
Page 30
A-2392 Wienerwald, Austria +43 2238 203 36, office@solflex.eu IM-10/2020-ENG Erste Bank AG, IBAN AT702011129323600200, BIC IBAATWWXXX, UID ATU65324348, FN 337206t, Gerichtsstand Wiener Neustadt, Austria All business transactions based on our Terms and Conditions, available at www.solflex.eu. Subject to change without prior notice.
Need help?
Do you have a question about the SonaSafe HW Series and is the answer not in the manual?
Questions and answers