Download Print this page

Vaquform DT2 Quick Start Manual

Download this manual

QUICK START

GUIDE

Page 1 QUICK START GUIDE...
Page 2 Lift the Vaquform from the front Remove the top foam. Set and back of the heater. Set it on a aside the handlebar, tool kit, flat surface then remove the foam and accessories. and strap. UNBOXING A B C D Remove the plastic sheets.
Page 3 HEATER TEST FORM MAGNETS Unlock the toggle clamp Return the upper sheet clamp frame 2mm x1 (M3 x 12) Attach four magnets to the heater following the diagram below. Lift the upper sheet clamp frame Lock the toggle clamp then remove the test form.
Page 4 HANDLEBAR MESH & FILTER Raise the handlebar then remove the mesh from the plastic. 5mm x1 (M6 x 25) Lock the linkage. Place a filter on the second vacuum port. Return the mesh on top of the platen. Screw the handlebar onto the linkage and the shoulder cap.