Download Print this page

Lean Cars SCUDERIA FERRARI Operation Instructions

Pedal go-kart

Download this manual

Repair and Maintenance

1) Regularly wipe it with a piece of dry cloth.

2) Check the bolt and nut for connecting and tighten them if necessary.

3) Check whether the chain of the drive is unblocked; adjust it if necessary, and clean and

lubricate it as well.

4) The rotatable parts of baby car should be often examined to see whether foreign matters

hinder the rotation and keep a normal lubrication condition.

MADE IN CHINA

K07-SMS-162-002

002-01

SCUDERIA FERRARI

PEDAL GO-KART

Read Operation Instructions Carefully Before Use

Produced under license of Ferrari Spa. FERRARI, the PRANCING HORSE device,

all associated logos and distinctive designs are property of Ferrari Spa. The body

designs of the Ferrari cars are protected as Ferrari property under design,

trademark and trade dress regulations.

Need help?

Do you have a question about the SCUDERIA FERRARI and is the answer not in the manual?

Page 1 Repair and Maintenance SCUDERIA FERRARI 1) Regularly wipe it with a piece of dry cloth. PEDAL GO-KART 2) Check the bolt and nut for connecting and tighten them if necessary. 3) Check whether the chain of the drive is unblocked; adjust it if necessary, and clean and lubricate it as well.
Page 2 VI. WARNING Dimensions of entire car 1. PRODUCT WARNING 1) Product assembly should only be undertaken by a responsible adult. 2) This product can be disassembled and the small parts may be swallowed by small children. Children using this product must be under the supervision of an adult at all times. 3) This product must be thoroughly checked for safety before allowing a child to use it.
Page 3 V. Simple Fault Removal Guidance III. Assembly Diagram 1.Mount the front iron stand Problems Check Check whether screw caps Check the bolt and nut for connecting and tighten them if necessary. and screws are tightened up. Check whether the chain Adjust the chain if necessary, and clean and lubricate it as well.
Page 4 5. Mount the seat 8.Install flag pole 9. Assembly completion drawing Mount the seat on the car body. Tighten the screws and nuts fixed component for Insert the flag into the hole at the rear of the toy car. the seat in No.1 screw kit. IV.