Advertisement
Advertisement
Table of Contents
Summary of Contents for Svedholm Unit
- Page 1 SVEDHOLM DESIGN AB Unit 2021-06-09...
- Page 2 Unit Design by Malin Berglund Anna Sjöberg A flexible modular shelf in perforated powder coated steel. Shelf H460 × W230 × D240 mm Bookend W180 × H100 mm...
- Page 3 How to assemble your Unit shelf • Start by checking that you have the assembly template, the back plates and the shelves. • You need the following tools to assemble the Unit shelf: drill / screwdriver and screws suitable for your wall type.
- Page 4 Tripp trapp Assembly instructions Lay out the assembly template on the Remove the assembly template from floor and mark where the back plates the wall. should be placed on the template Screw the back plates with the with a pencil. NOTE that the assembly arrows facing upwards on the wall.
- Page 5 Fyrklöver Assembly instructions Lay out the assembly template on the Remove the assembly template from floor and mark where the back plates the wall. should be placed on the template Screw the back plates with the with a pencil. NOTE that the assembly arrows facing upwards on the wall.
- Page 6 Stege Assembly instructions Lay out the assembly template on the Remove the assembly template from floor and mark where the back plates the wall. should be placed on the template Screw the back plates with the with a pencil. NOTE that the assembly arrows facing upwards on the wall.
- Page 7 Svedholm Design AB +46(0)10-190 20 80 · INFO@SVEDHOLM.SE · WWW.SVEDHOLM.SE...
Need help?
Do you have a question about the Unit and is the answer not in the manual?
Questions and answers