Peiter ArtMatic multi Instruction

ArtMatic multi remote control
Totally enriched, in detail well-finished, honouring the original design that gave the success obtained
till today.
Technical features:
Number of channels: 4
Code: fixed, rolling
Frequency: 280-868 MHz
Power supply: 3V, battery type CR2032
Dimensions: 60x35x10 mm
Best position for the duplication
FIXED CODE DUPLICATING PROCEDURES
1. While pressing the button 1 of the ArtMatic, at the same time press 4 times the 2 button.
2. Release both buttons. Now the ArtMatic LED emits a short flash every 2 seconds.
3. Place the original remote control to be programmed in front of the ArtMatic, at about 5 cm of distance
(as shown in the picture).
4. Press and retain pressed the button of the original remote control and wait for a change flash (as a faster
flash) of ArtMatic LED that confirms the correct learning of code.
5. While the LED is flashing, press the button of the ArtMatic where you want to program the code just
learnt, and retain pressed until the LED switches off.
6. The copy has been happened with success. Now check on the automation the correct functioning of the
new ArtMatic remote control.
Notes:
• The ArtMatic memory is completely re-writable.
• To duplicate further buttons of ArtMatic, please repeat the operation from the step 1.
96-500 Sochaczew, ul. 15-go Sierpnia 33a
tel./fax +48 46 862 34 88, tel. serwis +48 513 153 944
tel./fax +48 22 379 79 44 www.peiter.pl, peiter@peiter.pl
www.peiter.pl
NIP: 837-135-72-55, Regon: 140146548
Credit Agricole Bank Polska S.A.
19 1940 1076 5239 5305 0000 0000
Instruction