1 Introduction to the fingerprint solution A fingerprint sensor is integrated with the time terminal. The fingerprint sensor is used for enrolling user’s fingerprints, storing fingerprint templates and for identifying users. No images of the fingerprints are stored. Instead, a data model (a set of data points) of the fingerprint, called a fingerprint template, is stored locally on the fingerprint sensor in the terminal.
4. Enrol mode. All users who shall use the fingerprint sensor on a terminal must be enrolled on the local terminal. To enter Enrol mode: a) Log in as Admin on the Time and Attendance application running in the terminal. b) Depending on the Time and Attendance app used, select the User to be enrolled if applicable.
5.2 Delete users’ fingerprint templates Templates for a user can be deleted by first entering the users Global ID- value and then pressing the Delete button. In the footer it will first say ”Delete requested” and after a while ”Delete performed”...
Page 6
d) Press finger first time When the message says, “Press finger” and the light indicator is solid white press the finger firmly down on the glass surface of the fingerprint sensor. Try to cover as large area of the glass surface as possible.
Page 7
g) Second scan finger press Now firmly press down the same finger on the glass surface to repeat step (d) above. h) Remove finger second time When “Remove finger” is shown move the finger away from fingerprint sensor for a second time to repeat step (e) above.
Page 8
6. Examples of reasons for an unsuccessful enrolment a) The finger has already been enrolled on the fingerprint module. b) The finger was pressed too softly. c) The finger was not pressed in the same way during the three enrolment steps. d) The finger covered a too small area of the fingerprint sensor during the enrolment steps.