Table of Contents
Advertisement
Quick Links
40" IN-WALL FIREPLACE
ITEM # 95032
OWNER'S MANUAL AND SAFETY INSTRUCTIONS
SAVE THIS MANUAL. KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY,
OPERATION, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT'S
SERIAL NUMBER ON THE BACK OF THE MANUAL, OR THE MONTH AND YEAR OF PURCHASE IF
PRODUCT HAS NO SERIAL NUMBER
FOR QUESTIONS, PLEASE CALL CUSTOMER SERVICE: 909.628.0880
Advertisement
Table of Contents
Summary of Contents for XtremepowerUS 95032
- Page 1 40” IN-WALL FIREPLACE ITEM # 95032 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL. KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATION, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL, OR THE MONTH AND YEAR OF PURCHASE IF PRODUCT HAS NO SERIAL NUMBER FOR QUESTIONS, PLEASE CALL CUSTOMER SERVICE: 909.628.0880...
-
Page 2: Safety Information
SAFETY INFORMATION Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in injury and/or property damage. Save all warnings and instructions for future reference. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. -
Page 3: Carton Contents
INSTALLATION CARTON CONTENTS Please retain all packaging until you have Heater checked and counted all the parts and the Wall fixing bracket and screws contents of the hardware pack against the Remote control parts list. 1 x bracket and one pc bottom bracket The hardware pack contains small items 8 x 4x30mm top bracket2pcs 4*8mm to fix tempered glass which should be kept away from young children. - Page 4 INSTALLATION Put the crystal stone to ember bed. First, take off Fix the tempered glass with 2pcs of 4*8mm white glass from appliance. Then put crystal stone on screws on both sides as provided.(Fig.5) ember bed. • Place the front glass surround over the front of the Manual Operation fire aligning the slots in the bracket at each side of The switches located at the center right hand side...
- Page 5 INSTALLATION Take the glass from the appliance first, then gently Fix the tempered glass with 2pcs of 4*8mm screws put the appliance to the cut hole by two persons. provided.(Fig.5) Please see Fig.1. For optimum viewing, mark the left and right screws ( fixing positions on the wall in accordance with the appliance’s holes;...
-
Page 6: Remote Control
INSTALLATION PRODUCT INFORMATION • The standby switch located at the center right hand side of the fire must be first switch on. • It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more than once within two seconds for correct operation. -
Page 7: Led Bulb Replacement
INSTALLATION DO NOT mix old and new batteries. DO NOT use rechargeable silver oxide cell batteries with remote control unit. DO NOT mix alkaline. Standard (Carbon-zine). Or rechargeable (Nickle - Cadmium) batteries. DO NOT dispose of batteries in fire. Improper disposal may cause batteries to leak or explode. When using this electrical appliance, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to person, including the following This heater must be used on an AC supply only and the voltage marked on the heater must correspond to the... -
Page 8: Maintenance
MAINTENANCE LED BULB REPLACEMENT NOTE: The flame effect on this electric fireplace insert is created by LED Bulbs. The life of these LED bulbs will be 100,000 hours. The users are not recommended to Replace the LED Bulbs. For any reason should the bulbs stop working properly, contact a Qualified technician. -
Page 9: Please Read The Following Carefully
DISCLAIMER PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.