Advertisement
Table of Contents
KINGTONE SWITCH INSTALLATION
Install The Kingtone Switch As Follows
1. Solder the Kingtone Switch as shown in the diagram.
2. Reassemble the guitar, but leave the Kingtone switch on the outside of the guitar.
5. Remove plastic protector tape from the slide switch.
4. Make adjustments to the treble bleed settings until you're happy.
5. Open the guitar back up and tightly install the Kingtone Switch with washer and nut.
White
Red
VOLUME POT
Black
Add the White, Red and Black wires to the volume pot as shown.
If installing the Kingtone Switch on a Strat guitar, we recommend using the remaining tone
pot to control either all pickups or just the middle and neck.
Use the wire taken from the middle leg of the old tone control and add
it to the remaining tone control's middle leg and solder in place.
PLEASE CHECK OUT THE KINGTONE SWITCH INSTALLATION VIDEOS
www.kingtoneguitar.com/instructions
Advertisement
Table of Contents
Summary of Contents for KingTone Switch
- Page 1 2. Reassemble the guitar, but leave the Kingtone switch on the outside of the guitar. 5. Remove plastic protector tape from the slide switch. 4. Make adjustments to the treble bleed settings until you’re happy. 5. Open the guitar back up and tightly install the Kingtone Switch with washer and nut. White VOLUME POT Black Add the White, Red and Black wires to the volume pot as shown.
- Page 2 KINGTONE SWITCH SUGGESTED SETTINGS FENDERY SUPER BITE LAWRENCE SMITH SUBTLE MOJO ENHANCE J.S. BYPASS DUNCAN RESTORE KINGTONE LINDY...
Need help?
Do you have a question about the Switch and is the answer not in the manual?
Questions and answers