Download Print this page

Everwood Cordoba Assembly Instructions

3 piece seating set

Download this manual

Questions, problems, missing parts with this product? Do not return to your

retailer,please call our customer service department 9:00 a.m. to 5:00 p.m.

Eastern Standard Time Monday through Friday Phone # 1-800-457-4652

or contact us at www.numarkcustomerservice.com

Care and Maintenance

Though its powder-coated finish is rust-resistant, steel is prone to rust over time with exposure to the elements. In case of rust or scratches,

lightly sand the affected area and apply touch-up paint. To maintain the finish periodically apply wax with a soft cloth.

Wash frames with a mild solution of soap and water; rinse thoroughly. Do not use bleach or solvents.

Do not store anything on tabletop. Use furniture covers or store indoors during cold or inclement weather.

Everwood Cordoba 3 piece seating set

ASSEMBLY INSTRUCTIONS

SR-K-137E/3

Need help?

Do you have a question about the Cordoba and is the answer not in the manual?

Page 1 Everwood Cordoba 3 piece seating set ASSEMBLY INSTRUCTIONS SR-K-137E/3 Questions, problems, missing parts with this product? Do not return to your retailer,please call our customer service department 9:00 a.m. to 5:00 p.m. Eastern Standard Time Monday through Friday Phone # 1-800-457-4652 or contact us at www.numarkcustomerservice.com...
Page 2 Parts table top (Attached with 8 bolts and 8 washers) (Attached with 4 bolts and 4 washers) connector bar left arm right arm seat back Hardware Ga x 8 +1 spare Gb x 8 +1 spare Ge x 1 Gc x 8 Gd x 1 Sunk Screw Assembly Instructions Sheet...
Page 3 Assembly instruction Gb x 4 Bolt (Remove from the leg) Gc x 4 Metal washer (Remove from the leg) Do not tighten completely. Repeat procedure for the other three legs. Turn over the side table, securely tighten all bolts by using Allen wrench (Gd) in a diagonal pattern. Adjust the table level by twisting knobs on the bottoms of the legs.
Page 4 Assembly instruction Ga x 4 Sunk screw Note: the arrow points per drawing when assemble. Do not tighten completely. Repeat procedure for the other holes. Once all bolts and screws are in place, go back and tighten all bolts and screws by using Allen wrench (Gd).

Sr-k-137e/3