Advertisement
_____________________________________________________________________
1 General Information
1.1 Warning Laser Safety
The laser sources specified by this user guide are classified according to IEC 60825-1 (2007)
Laser Notice No. 50 dated 2007-June-24 and comply with CFR 1040.10 except deviations per
Laser Notice No. 50, July 2001 Key Feature Number 4.
This device is a Class 1M laser product for use only under the recommended operating
conditions and ratings specified in this document. Use of controls or adjustments or
performance of procedures other than these specified in this product datasheet may result in
hazardous radiation exposure.
Do not view the laser output from this device directly with optical instruments (e.g., eye loupes,
magnifiers, microscopes). Viewing the laser output with certain optical instruments within a
distance of 100mm may pose an eye hazard. The class 1M laser product definition is based on
all conditions defined in this section.
Please pay attention to the following laser safety warning: Under no circumstances look into the
end of an optical cable attached to the optical output when the device is operational. The laser
radiation can seriously damage your eyesight. Do not enable the laser when there is no fiber
attached to the optical output connector. The laser is enabled by pressing the 'Laser on' button
in the operating software delivered with the instrument. The laser is on when the red LED on the
front panel of the instrument is lit. The use of optical instruments with this product will increase
eye hazard.
In doubt about laser safety requirements consult a trained laser safety instructor for local safety
requirements of this product.
1.2 Compliance Statement Electromagnetic Compatibility and device safety
Hereby, we confirm that the system has been demonstrated and audited for compliance for the
following directives.
1.2.1
International
IEC 60950-1:2005, modified+Cor.:2006 + A1:2009, modified
CISPR 11:2003 in accordance with EN 61326-1: 2006
1.2.2
United States of America
FCC 47 CFR Part 15, Subpart B Class A, Measurement process ANSI C63.4 (2009)
1.2.3
European Union
EN 55022:2011
EN 61326-1: 2006
EN 61000-6-2: 2006
EN 61000-6-4: 2011
EN 61000-3-2: 2010
EN 61000-3-3: 2009
1.3 Limitation of communication interfaces
Operation of all USB Ports is limited to a maximum cable length of 3m and a maximum length of
30m for all Ethernet ports present.
1.4 European WEEE Directive Compliance
ID PHOTONICS has established processes in compliance with the Waste Electrical and
Electronic Equipment (WEEE) Directive, 2002/96/EC. This product should not be disposed of as
User Manual
3
CoBrite
INVISIBLE LASER RADIATION
DO NOT VIEW WITH
OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
(IEC 60825-1/2007)
Advertisement
