Advertisement
Quick Links
Instruction Manual
Ice Maker & Shaver ZBS-20A
Thank you for choosing our ice maker
Please read this Instruction Manual carefully before using this product so as to ensure proper use.
After reading this manual, please keep it in a safe place and refer to it when necessary.
Advertisement
Summary of Contents for IKER ZBS-20A
- Page 1 Instruction Manual Ice Maker & Shaver ZBS-20A Thank you for choosing our ice maker Please read this Instruction Manual carefully before using this product so as to ensure proper use. After reading this manual, please keep it in a safe place and refer to it when necessary.
- Page 2 Description Front top lid Ice full sensor Viewing window Water buoy Evaporator Water suction hole Ice basket Drain plug Back top lid Max water filling line Control Panel Back cover Middle Frame Water Inlet Hole Handle Shaved ice bowl Housing Shaving paddle Decoration door Knife...
- Page 3 Before/First Use of Your Ice Maker 1.During transportation, the incline angle of the cabinet should not be over 45° .Do not turn the Ice maker upside down. As this may damage the compressor and sealed system. 2.Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.
- Page 4 Operating Instructions Step 1. Shaved ice may melt,so it is strongly recommended that a drain hose at bottom of unit be connected. The steps are as follows. drain pipe Sketch for step 1 Step 2. Open the lid,take out of the ice basket and fill the water reservoir with water. Note: Make sure the water is not over the bottom of the ice collecting tray.
- Page 5 Step 2.4 Stick the filter between the buckles(the end of the filter with an arrow should be placed towards the left). Step 2.5 Insert the water pipes to both sides to the filter .But do not connect them to the machine in advance.
- Page 6 Step 2.8 If you want to take off the pipe connected to the water inlet hole, take off the blue ring named as A(if any)first, then press the white ring at the outer side named as B,and pull out the pipe simultaneously Step 3.
- Page 7 Caring 1.Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil.
- Page 8 14. WARNING – Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Troubleshooting 1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic shovel causing it to jam.