Springburo CLIPPER Operating Instructions Manual

CLIPPER
TEST PROBE
Operating Instructions
Version: 1.3
Clipper Test Probe
EC Declaration of Conformity
The product is marked with this symbol to indicate
that it conforms to the applicable European Union
requirements per Low Voltage Directive LVD
2006/95/EC. Compliance was demonstrated to the
following specification as listed in the Official
journal of the European Communities.
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control and laboratory use – Part 031: Safety requirements
for handheld probe assemblies for electrical measurement and test.
EU RoHS Compliance
The Probes and it's accessories conform to the 2011/65/EU RoHS2
Directive, as they have been classified as Industrial Monitoring and Control
Equipment (per Article 3, Paragraph 24).
General Safety Information
Observe generally accepted safety procedures in
addition to those listed here to avoid personal injury or
damage to equipment. The overall safety of any
system incorporating the Clipper Test Probe is the
responsibility of the person using the system.
Because of its application area (the measurement of high voltages), it is
particularly important to read the connection instructions and safety
instructions listed below.
P/N CLP1500V15A1 V1.3
Operating Instructions
Page 1