KAILI ELECTRONICS KD-C888Pro User Manual

UHF Super Receiving

Scanning

Vox
Alarm Function
Chinese/English Voice Prompt

Wide/Narrow Band Selection

High-Low Power Selection

Busy Channel Lockout
Low Battery Warning
50 CTCSS/208 DCS

Charging the Battery

1.The battery is not charged in the factory,please charge the
battery under the environmental temperature 5—40℃ before
using.
2.After purchasing or long-term storage(more than two months),
charging the battery for the first time can not reach its saturation
capacity,repeat charge/discharge for twice or three times to
make battery capacity achieve the best state.
3.Before charging,please power off the transceiver,using the
transceiver during charging may affect correct charging.
4.If the battery has been charged fully,please do not charge it
again,otherwise the service life of the battery may be shorten or
may be damaged.
5.If the service time is significantly reduced even after
completely correct charging,the battery can not be used any
more,please replace a new battery.

BASIC OPERATION

Power Switch(Volume Knob)

Turn the power switch to turn on/off the power.
When power-on,turn the volume knob to adjust the volume.

Channel Selection

Turn the channel knob to adjust the channels.

PTT

Press this button whenever you wish to talk with the user of
the other radio.

Monitoring

Press 【UP】 key to enter into the monitor mode,
release it to exit.
Scanning
It is convenient for the user to search for calls from other
channels.When"Side Key 2" in the software is programmed
to the scanning function,press 【DOWN】 key to enter into
the scanning mode,the transceiver will start to scan with the
current channel;Operate it again to exit.

Emergency Alarm

When"Side Key 2" in the software is programmed to the
alarm function,press 【DOWN】 key to alarm;
Press PTT key to exit.