Advertisement
INTRODUCTION
The Spiral Fluorescent Lights 425, 925 and 1625 are available as:
Light with Softbox; Light with Reflector, Soft Diffuser and Reflector Supporting Rod;
Light with Light Intensifier.
Utilizing Cold Cathode Fluorescent Spiral Light Bulbs with a color temperature of 5200
Kelvin, the light is steady and flicker free. It assures you of uniform quality pictures
reproducing correct colors.
Main Parts
1.
SPIRAL FLUORESCENT LIGHT
OPERATING INSTRUCTIONS
SFL 425, SFL 925, SFL 1625
1
Sleeve Locking Knob
2
Mounting Sleeve
3
Mounting Frame
4
Frame Locking Knob
5
Body
6
Setting Screw Knob
7
Reflector
8
Hole for Supporting Rod
Advertisement
Table of Contents
Summary of Contents for STUDIO PRO SFL 425
- Page 1 SPIRAL FLUORESCENT LIGHT OPERATING INSTRUCTIONS SFL 425, SFL 925, SFL 1625 INTRODUCTION The Spiral Fluorescent Lights 425, 925 and 1625 are available as: Light with Softbox; Light with Reflector, Soft Diffuser and Reflector Supporting Rod; Light with Light Intensifier. Utilizing Cold Cathode Fluorescent Spiral Light Bulbs with a color temperature of 5200 Kelvin, the light is steady and flicker free.
-
Page 2: Installation
2. INSTALLATION a) Installing the Light: Generally the Light is to be installed on a light stand. A light stand with sufficient sturdiness and an appropriate leg-spread diameter which matches the size and weight of the particular light model must be used. Loosen the Sleeve Locking Knob to clear the passage inside the Mounting Sleeve. -
Page 3: Operation
d) Installing Spiral Fluorescent Lamps Make sure the lamps are for the local voltage. Screw them into the sockets on the front of the Body. e) Installing the Diffuser Panel The Diffuser Panel has 2 rectangular “Wings”, one bigger than the other (Fig. 3), sticking out from 2 of its edges. - Page 4 b) Addition of Intensifier (Optional) i) Function The Intensifier is something similar to a snoot in terms of its function and is for concentrating the light beams into a smaller area, thus enhancing the brightness for that area. ii) Installation There are 2 Mounting Plates on 2 opposite sides of the frame of the Intensifier (Fig.
- Page 5 6. CAUTION a) The light is designed solely for indoor usage. b) Always turn off the light or unplug it when not in use. c) The exterior of the unit can reach a temperature of as high as 55 degrees Celsius during operation.
-
Page 6: Specifications
SPECIFICATIONS Model No. SFL 425 SFL 925 SFL 1625 Rated Power 100 Watt 225 Watt 400 Watt Operating Temperature 5-35 degree Celsius Bulbs YPZ 120/25 SD, 110-120V, 25 Watt Color Temperature 5200 Kelvin Power Levels Full Full, 2/3, 1/3 Full, 5/8, 3/8...
Need help?
Do you have a question about the SFL 425 and is the answer not in the manual?
Questions and answers