Table of Contents
Advertisement
Quick Links
Battery System Tester
Battery System Tester
1. Description and operating modes .................................................................. 1
2. Abbreviations ................................................................................................. 2
3. Battery test mode .......................................................................................... 3
4. System test mode ........................................................................................... 4
4.1. Cranking voltage test ................................................................................... 4
4.2. Charging test with no loads ......................................................................... 4
4.3. Charging test with loads turned on ............................................................. 5
5. Language select .............................................................................................. 5
6. Adjust the display brightness ......................................................................... 6
7. Fast test mode ................................................................................................ 6
8. Technical specifications .................................................................................. 6
IMPORTANT!!!
Read the following instructions below to avoid damage to the battery
or injuries! Lead acid batteries can produce explosive gas! Keep good
ventilation around the battery being tested!
1. Description and operating modes
Ditex battery tester due to its advanced testing technology, allows to easily, quickly and
accurately test the healthy state of the battery, common fault of the vehicle starting system
and charging system, which can help you to find the problem quickly and accurately. You can
test all automotive lead acid batteries types, test battery voltage during cranking and access
the alternator condition by measuring the charging voltage at idle speed.
The Battery System Tester has 2 modes of operation:
- Battery condition test - Measurement of actual capacity, internal resistance, charge rate
(SOC) and battery health (SOH);
- System test divided into 3 sub tests: Engine test voltage test, engine idling and under load
test.
Version 1.0/2018-01-26
Operating manual
BT-D1
Operating manual
Table of contents
- 1 -
AUTODITEX
www.autoditex.com
Advertisement
Table of Contents
Summary of Contents for AUTODITEX BT-D1
- Page 1 Battery System Tester Operating manual AUTODITEX Battery System Tester BT-D1 Operating manual Table of contents 1. Description and operating modes ..............1 2. Abbreviations ....................2 3. Battery test mode ..................3 4. System test mode ................... 4 4.1. Cranking voltage test ................... 4 4.2.
- Page 2 Battery System Tester Operating manual AUTODITEX 2. Abbreviations AGM battery Absorbent Glass Mat (AGM) batteries have very low internal resistance and is capable to deliver high currents on demand and offers a relatively long service life, even when deep cycled.
- Page 3 Battery System Tester Operating manual AUTODITEX 3. Battery test mode Note: Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all vehicle doors and the trunk lid. Make sure the battery terminals are clean and wire brush them if necessary.
- Page 4 Battery System Tester Operating manual AUTODITEX “TEST ERROR” - The tested battery is bigger than 2000CCA or the clamps are not connected properly. Please fully charge the battery and retest after excluding both the above mentioned reasons. If the reading is the same, the battery should be replaced immediately! - Press the “ENTER”...
- Page 5 Battery System Tester Operating manual AUTODITEX connection is loose or heavily corroded, clean or replace the cable and retest. If the belts and connections are in good condition, replace the alternator. “ALT, IDLE VOLTS HIGH” - The voltage output from the alternator to the battery exceeds the normal limits of a functioning regulator.
- Page 6 Battery System Tester Operating manual AUTODITEX 5. Press the “◄ ►” button to select the language you want. 6. Press the “Enter” (MENU) button to confirm selection and return to the LANGUAGE SELECT display. 6. Adjust the display brightness 1. Connect the Battery System Tester to a vehicle battery.
Need help?
Do you have a question about the BT-D1 and is the answer not in the manual?
Questions and answers