Advertisement
Quick Links
STANDARD INSTALLATION
PEEL, STICK & SEAL
How to install
glass splashbacks
What you need
Tape Measure
Silicone Sealant -
Low Modulus Type
Before you start
Check that your splashback
1
fits into the required space.
Easy to apply
1
Peel off backing
Make sure all corners are safe from
hard surfaces. Take care to peel off
the protective film back and not
the self-adhesive backing.
Sealant Gun
2
Splashback to
go here
2
Stick on the wall
Place the bottom edge of the
splashback to the rear of the hob.
Push it to the wall and apply firm
even pressure with the cloth.
Clean Cloth
110mm
Your splashback must be at
least 110mm away from the
nearest heat source.
3
Using the Silicone Sealant.
No more than 2.5mm in thickness.
1 x Splashback
Check the surface
3
is perfectly flat,
non-porous, dry
and dust free.
Our splashbacks
are made from
toughened safety
glass so they
cannot be cut.
Seal the edges
Advertisement
Summary of Contents for splashback 781JJ
- Page 1 Place the bottom edge of the Using the Silicone Sealant. hard surfaces. Take care to peel off splashback to the rear of the hob. No more than 2.5mm in thickness. the protective film back and not Push it to the wall and apply firm the self-adhesive backing.
- Page 2 When cleaning the splashback use hot water and a mild soap detergent. Do not use abrasive cleaners. Leave the Splashback for at least 45 minutes to cool before wiping, as in extreme cases, applying a cold cloth to a hot surface can cause the glass to crack/shatter.
Need help?
Do you have a question about the 781JJ and is the answer not in the manual?
Questions and answers