Download Print this page

Stoov Charge6 Assembly Instructions Manual

Download this manual

Assembly instructions

Charge6

Need help?

Do you have a question about the Charge6 and is the answer not in the manual?

Page 1 Assembly instructions Charge6...
Page 2 EN | Product information WARNING: Read carefully before use • Only use the AC adapter enclosed with your Stoov® products. Using a different charger may cause irre- placeble damage to the product and can be danger- ous. • Do not expose the product to excessive heat from other sources.
Page 3 What’s included? • 1x large strain reliever • Metal frame • 6x small strain reliever • Metal inlay tray • 4x nylon washers • Wooden board • 4x wood screws • Power strip Assembly instructions Step 1 Place the large strain reliever around the wire of the power strip.
Page 4 Step 2 Place the 6 smaller strain relievers around 6 power cords of your Stoov® chargers. Place the cords with the strain reliever on the metal tray. We advice to place to strain reliever 25cm from the end of the wire.
Page 5 Step 3 Tie up the extra length of the cords with a tie-wrap or an elastic. And place the chargers in the sockets of the pow- er strip. See image on the previous page for the position of the chargers. Step 4 Now place back the metal tray in the frame with the pow- er strip and all the chargers.
Page 6 Step 6 Place the wooden board on top of the washers and the tray. Screw the wooden board to the tray and metal frame with the 4 wood screws.See image below to see how to place the wooden screws.
Page 7 Stoov B.V. Rembrandtlaan 14a 3723 BJ Bilthoven The Netherlands +31 30 751 97 16 hello@stoov.com @mystoov www.stoov.com...