AlteredStates BT Plus PRO Quick Start Quide

BT Plus PRO

Component list: BT Plus PRO unit, Power Charger, Ear clips, Gel Pads, Instructions

SIZE 2 inches x 3 inches x ¾ inch (5cm x 8cm x 2cm)

POWER SUPPLY Rechargeable batteries (charger supplied)

TIMER 5, 10, 15, 20, 25, 30 minutes

FREQUENCIES (Alpha Theta Stim³ and BT11)

0.5Hz The 0.5Hz DELTA brainwave frequency, normally associated with deep sleep and release of deeply embedded stress

patterns. May help with pain relief (temporarily), natural opiates released, supports the immune system, stress buster.

1.5Hz May experience pain relief and can promote quiet sleep

5.0Hz 'In the Palaces of Memory' they suggest 5Hz as being the optimum learning frequency. Even as you read these words,

a tiny portion of your brain is physically changing. New connections are being sprouted – a circuit that will create a stab of

recognition if you encounter the words again. Supports the body to repair and heal.

Read "In The Palaces of Memory" by George Johnson.

7.83Hz The 7.83Hz Alpha Theta (border) brainwave frequency and it's associated with a relaxed, but very focused mental

state. This is also the Schumann frequency. Ideal for meditation and relaxation.

Table of Contents

Need help?

Do you have a question about the BT Plus PRO and is the answer not in the manual?

Page 1 BT Plus PRO Component list: BT Plus PRO unit, Power Charger, Ear clips, Gel Pads, Instructions Specifications SIZE 2 inches x 3 inches x ¾ inch (5cm x 8cm x 2cm) POWER SUPPLY Rechargeable batteries (charger supplied) TIMER 5, 10, 15, 20, 25, 30 minutes FREQUENCIES (Alpha Theta Stim³...
Page 2 100Hz Feel better, blast those moods! BT11 Brain tuner, endorphin release, natural mood enhancer. Read “Hooked?” by Dr. Meg Patterson CURRENT 10 to 600µA WAVEFORM Bipolar asymmetric rectangular waves, 50% duty cycle INTENSITY CONTROL 20 steps OPERATING INSTRUCTIONS  Before any session it is recommended to drink at least 250-500mls of purified, ozonated or distilled water. This ensures the body is not dehydrated allowing a more positive skin resistance with the electrodes.
Page 3 To increase intensity, press and release the up button. Each time the button is pressed the intensity level increases. The next LED up will only light after approximately 4 presses of the up button. Maximum intensity is when the top LED is lit. To decrease intensity, press and release the down button.
Page 4 1. Open the unit and remove the jumper connection you connected when first getting the unit. 2. Plug in the Battery charger. (Charge LED should light up) 3. While the Charger is plugged in, reconnect the jumper. (The Charge LED should stay on. If it doesn't, remove and replace the jumper several times until it does) 4.