GateGoing Gago Installation Instructions

Gago is a smart IoT ("Internet of Things") device
designed to open any gate, barrier, parking lot or door
operated by a motor or magnet. No matter where you
purchased the gate and whether it has a remote control
or other means of access, Gago knows how to connect
with everyone. The installation is simple and does not
require technical knowledge, the instructions are clear
and easy to understand.
Gago operates using the GateGoing app and offers an
improved user experience relative to any other
controller thanks to its advanced technology that
includes an easy and convenient user interface in
multiple languages and a wide range of operating
options suitable for everyone.
This new generation of Gago features a smart remote
control that allows the gate owner to activate or
deactivate it as they wish. The remote allows you to
operate up to four gates which can be set up remotely.
Each Gago has advanced options that include opening
a gate by dialing a unique number that does not reveal
the gate number and therefore cannot be hacked, an
online management system that allows the community
manager or house committee to conveniently manage
users and grant permissions as needed (additional fees
may apply).
Gago connects to the cloud services via the cellular
network and receives any standard SIM card. Gago can
be purchased with a low-cost GateGoing SIM card.
Gago offers an enhanced user experience that
includes, among other things, a super fast response
time, entry via QR code scanning, connection to LPR
cameras, RFID sensor, smart automation commands
like automatic opening when reaching the gate, opening
and closing with one button, delayed opening and
more. Gago is fully compatible with Google Assistance
and Alexa.
Installation instructions
This guide describes the hardware installation and app
installation steps. Before we get started, make sure that
the latest version of the app is installed on your phone,
otherwise please visit the app store using the link below
and install the latest version:
http://download.gategoing.app
Attention
The accessories used by Gago have been carefully
selected, do not use non-genuine accessories as this
may result in improper operation of Gago and even
damage. The connector and antennas supplied with
Gago should be used. If the SIM card is already
installed inside the unit, it is necessary to activate it. If
you are missing accessories, please contact us and we
will be happy to help.
Hardware installation
Use the dedicated connector to connect the motor port
(dry contact) and the limit switch (if one is installed in
the gate). Connect the antennas as indicated, GSM
antenna on the right and remote control on the left (see
figure below). Connect voltage according to the
allowable range and you should see the status light
flash green after a few seconds. If your Gago has a SIM
installed, make sure it is activated or install another SIM
with a data package.
General overview
Power Voltage input 12-24VDC
Relay Relay, maximum load 60V 500mA
Switch Limit switch input (gate mode)
Reset Reset button
LED Status light
GSM Cellular antenna (marked with a
yellow stripe or GSM inscription)
Remote Remote control antenna (marked
with a red stripe or RC inscription)