Perma-Pipe PermAlert FluidWatch II Installation And Operation Manual

Perma-Pipe PermAlert FluidWatch II Installation And Operation Manual

Leak detection system

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Perma-Pipe PermAlert FluidWatch II

  • Page 2 The information contained in this manual, including but not limited to any product specifications, is subject to change without notice. PERMALERT (PERMALERT), A DIVISION OF PERMA-PIPE, INC., PROVIDES NO WARRANTY WITH REGARD TO THIS MANUAL OR ANY OTHER INFORMATION CONTAINED HEREIN AND HEREBY EXPRESSLY DISCLAIMS ANY WARRANTIES, INCLUDING IMPLIED WARRANTIES, OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE WITH REGARD TO ANY OF THE FOREGOING.
  • Page 3: Theory Of Operation

    ® The following instructions describe the installation and operating procedures for FluidWatch II Leak Detection Monitoring System. INTRODUCTION 1. The FluidWatch II system consists of a solid-state electronic monitoring unit connected to a sensor cable. 2. The following general precautions should be observed: 3.
  • Page 4: Power Requirement

    Figure 1 POWER REQUIREMENT The FluidWatch II Leak Detection System requires either a 10-30 VAC or 10-30 VDC power source. The power supply must be CE approved to maintain the CE approval of the FluidWatch II system. The fused incoming power is connected to terminal strip P2. The incoming power wires must pass through the ¾” cylindrical ferrite clamp-on bead.
  • Page 5: Output Relays

    far, the system will go into alarm, either "LEAK" or "BREAK" depending on the direction it is turned. If this happens, simply turn the pot in the opposite direction until the green LED turns on. The following chart lists the approximate values of wet cable required to activate an alarm for different sensitivity settings. Note the length of wet cable required is the length of “submerged”...
  • Page 6: Warranty

    WARRANTY Seller warrants that the PermAlert Leak Detection System (the "System") will be free from defects in materials and workmanship for a period of twelve (12) months from the date of first use of the System or eighteen (18) months from the date of shipment by Seller to Buyer of the System;...
  • Page 8 ©2016, PERMA-PIPE, Inc. All Rights Reserved. (6/16)

Table of Contents