Dan Clark Audio AEON 2 Quick User Manual

• Read instruction manual carefully and completely before
using this headphone.
• Keep the headphone, accessories, and packaging out of
reach of pets and children. This product contains small
parts which may present a choking hazard.
• Use only attachments, accessories, and spare parts
supplied or recommended by Dan Clark Audio.
Boot
Metal Jacket

Safety Instructions

Headphone Fit Adjustments

Adjust slider up or down
on both left and right sides
for proper t.

Attaching a Cable

*click*

Features

Driver: 62mm x 34mm Dan Clark Audio designed
single-ended planar magnetic.
Titanium "Memory Metal" headband.
Leather comfort strap.
Synthetic leather ear pads.
Matched drivers: +/- 0.5dB between 100-7KHz
• Protect your hearing from high volume levels. Permanent
hearing damage can occur when headphones are used
at high volume levels for extended periods of time.
• Do not expose headphone or accessories to extreme
temperatures.
• Always keep headphone dry.
You can adjust the t of your heaphone by re-positioning
the headband slider. To adjust the headband move the
sliders up or down until you achieve your desired
t. It may benecessary to remove thick glasses or hats to
achieve a proper seal between your head and ear pad.
An improper t cancause a bad seal resulting in poor
bass response.
Tip: Try inserting the arms of your glasses into the top of
the ear pad instead of resting them directly on your ears.
All Dan Clark Audio planar-magnetic products use
Hirose-style connectors. To attach your cable hold the
male connector by the boot and rotate it into the female
receptacle on the headphone until you feel it click into
place. To release the cable, pull down on the top of the
connector's metal jacket.