BEWARE of laser beam reflections off of mirrors or other reflective • surfaces Batteries PL-E Pro series is by default a 26650 host at 28cm in length. • 18650/16340 lithium-ion batteries may also be used with the included case reducers. Some lithium-ion batteries have flat-tops (as opposed to batteries with a “button-top”).
• AC wall adapters are not included in the packing list. If you have the right AC adapter, you can run the laser on AC without the batts needed. Operation ...
Page 5
PL-E Pro Mechanical Switch 1. Load Batteries Load "-" negative end of battery first into the host • Reattach the tail switch. • 2. Switch on the Tail Switch There are two options of tail switches: The Keylock Switch: Turn into the keylock on tailcap with the key •...
Page 6
The user can force switch off the laser at any state by using the tail • switch. PL-E Pro Series Code Switch 1. Load Batteries Load "-" negative end of battery first into the host • Reattach the tail switch. ...
Long Hold (3 seconds) the Power Select Button shifts laser into • Standby Mode. Pressing the Power Select Button will turn the beam on again. • 5. Switch the Laser Off In Standby Mode, depress/keylock the Tail Switch to switch off. •...
Page 8
Figure A is known as a “diverging beam.” In this configuration, the • beam begins as a narrow-gathered beam and eventually expands as the distance increases. Figure B is known as a “converging beam.” In this configuration, the • beam begins as a wide beam, but at certain distance will converge, i.e., come together, and then it will diverge again. ...
a very narrow beam will begin ignition, if there is enough intensity (the higher wattage equates to higher intensity). The target must also be taken into account. Light (not dark) objects will reflect a light source instead of absorbing it. On the other hand, a dark object will be able to absorb light better.