SERIES NIM PLEASE READ THIS MANUAL BEFORE USING THE PRODUCT Low Temperature Merchandisers Operation Manual Hussmann Monterrey, Mexico Carretera Mexico-Laredo KM. 1009 Cienga de Flores, Nuevo Leon 65550 Mexico Phone: (52) 81-8318-6400 Fax: (52) 81-8318-6496 Installation & P/N 2402195 NIM-6...
TABLE OF CONTENTS Introduction Inspection Location Clearance Shipping Braces Placement of Doors Leveling of the Cabinet Sealing Splashguard to Floor Grills Drain Tempered Glass Doors Display Pan Air Distribution Electric connections Serial plate Control of temperature Defrost time Clock Maintenance Technical Data Sheets IMPORTANT KEEP IN STORE FOR FUTURE REFERENCE...
INTRODUCTION The NIM – 6 and NIM-4 are low temperature self-contained cabinets, designed for pre-packaged frozen foods or Novelty Ice Cream products. Design features include self closing glass doors, CFC Free insulating foam, low rail height for ease of access, and a balanced refrigeration system for optimum energy savings.
LEVELING OF THE CABINET Cabinets must be installed level to ensure proper operation of the refrigeration system and to ensure proper drainage of defrost water. When leveling merchandisers, use a carpenter’s level as shown SEALING SPLASHGUARD TO FLOOR If required by local sanitation codes, or if desired by the customer, stainless steel splashguards may be sealed to the floor using a vinyl cove base trim.
GRILL The grill provides access to the condenser unit and the box which contains the electric connections. The grill is fastened with screws for initial shipping. DRAIN The cabinet is provided with a drain installed from the manufacturer; this drainage runs from the bottom of the cabinet to a condenser pan located in the condensing unit area.
DISPLAY PANS The NIM-6 is provided with 3 display pans which you should make sure are placed correctly and never operate the cabinet without these. If you use the case without these display pans the interior airflow and temperature in...
SERIAL PLATE The serial plate is located inside the cabinet. It contains the necessary information for the appropriate electric installation. Do not remove the serial plate under any circumstance. CONTROL OF TEMPERATURE The cabinet has an electronic control for control of case interior temperature. It is installed in the lower part of the cabinet.
Routine maintenance a) Verify that the blades of the evaporator and condenser motors rotate freely and that the motors work correctly. b) Verify that the drainage is not obstructed and the hoses in the condenser pan avoid spills of water after defrost c) Makes sure that the doors close easily and seal well d) Make sure the discharge honeycomb and the return grill are free of ice.
Need help?
Do you have a question about the NIM and is the answer not in the manual?
Questions and answers