Rysam RSN99V User Instructions

Model：RSN99V
FFP3 NR
USER INSTRUCTIONS
Failure to follow the instructions and warning on the use of this mask during all times of exposure can
reduce the effectiveness of the mask and could result in illness or disability.
A copy of the Declaration of Compliance will be provided with every smallest commercially available
package.
As with any respiratory device, the wearer must be adequately trained prior to use. Before use, the wearer
should always check the mask is in good condition- no dirt, no damage to headharness attachment etc

Limitation:

Do not use the respirator or enter or stay in a contaminated area under the following circumstances:
a Atmosphere contains less than 19.5% oxygen.
b If you smell or taste contaminant.
c For protection against gases or vapors.
d Contaminants or their concentrations are unknown or immediately dangerous to life or health.
e For sandblasting, paint-spray operations and asbestos treatment.
f In explosive atmospheres.

Warning:

1 This mask marked "NR", shall not be used for more than one shift.
2 Never substitute, modify, add, or omit parts in the configuration as specified by the manufacture.
3 This mask helps protect against certain particulate contaminants but does not completely eliminate
exposure to the risk of contracting disease or infection.
4 It is unlikely that the requirements for leakage will be achieved if facial hair passes under the face
seal.
5 Change the mask immediately if breathing becomes difficult or the mask becomes damaged or distorted.
6 Change the mask if a proper face seal cannot be achieved.

FITTING INSTRUCTION

1 Hold the particle half mask in position over the nose and mouth.
2 Pull lower strap over the head and fit around the back of the neck.
3 Pull the upper strap over the head positioning it just above the ears.
4 Ensure the nose clip is securely moulded around the nose, resting the ends against the cheek to obtain
a good seal.
5 To check for proper fit, cup both hands over the mask and exhale vigorously. If air leaks around the
nose, tighten the nose clip, if air leaks around the edge, reposition the headharness for better fit.
6 Repeat adjustments until the mask is sealed properly.
7 If a proper seal cannot be achieved do not enter the contaminated area or it may cause illness.