Page 1
Assembly Instructions Caution : You must read this before you proceed BAR TABLE Part List Label Picture Description Table Top Table Leg B Table Leg C Side Stretcher Cross Bar Page 1 of 6...
Hardware Label Picture Description JCBB M8 x 70mm ① + S/W 5/16" + F/W 5/16" x 22mm Allen Key M5 ② JCBC M6 x 45mm ③ + S/W M6 + F/W M6 x 13mm Allen Key M4 ④ FH SCREW #8 x 32mm ⑤...
Side Stretcher (D) This Bar Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Bar Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Page 4
Step 2 Place the Cross Bar (E) with Side Strecther (D) as shown. Then, fix the Cross Bar (E) with JCBC Bolt ③ using Allen Key ④. DO NOT FULLY TIGHTEN SCREWS. Step 3 Place the Assembled part that finished on step 2 onto the mounting position of the Table Leg.
Page 5
Step 4 Repeat step 1, Fix the Table Leg (B) and (C) with JCBB Bolt ① + Spring Washer + Flat Washer using Allen Key ②. Fix the Side Stretcher (C) with CSK Screw ⑤ using Screwdriver (not provided). In case the table wobbles, need loosen tighten the screw and bolts, and use your hand press the top of the table, to make sure the table eveness, and then full tighten the bolts sequence.