EZANDA 14166 Installation Manual

BEFORE INSTALLATION

· To insure proper installation, please read the following instructions carefully.
· Please make sure that the water supply has been shut off at the stop valve.
· EZANDA reserves the right to update product without notice.
Single Hole
Application
1
6
2
3
4
5
1.Install square Gasket ② onto Faucet Body ①.
Slide single hole faucet through the sink mounting hole.
Note: Escutcheon ⑦ is included for 3-Hole applications.
3-Hole
Application
6
2
7
3
4
5
2.Place Stainless Steel Washer ④ and Rubber
Washer ③ onto Mounting Studs ⑥ under the
sink, and tighten the Mounting Nuts ⑤ securely
as shown.
· Every once in a while, please rinse the faucet with lukewarm soapwater, and wipe it clean with a soft duster cloth.
Please avoid any abrasive cleaners, steel wools, or corrosive chemicals.
If you have any question or need help,
please visit
http://www.ezanda.com
8
9
3.Connect and screw on the Supply Hoses ⑧ to Valves ⑨.
4.Turn on faucet to check for leaks.
website
8
9