Lowenergie Dusk till Dawn Installation And Wiring Instructions

Dusk till Dawn Photocell Light Control Switch
DESIGNED TO SWITCH INDUSTRIAL AND DOMESTIC LIGHTING
Installation and wiring instructions
Please read the instructions fully before attempting installation
These controls are designed to switch a lighting load on and
off automatically at dusk and dawn. The units are
pre-calibrated to switch on at a light level which will ensure
that outdoor lighting is on when required, allowing for a 10
minute warm-up period for sodium or mercury discharge
lighting. They are however, suitable for use with all types of
lighting, i.e. tungsten, fluorescent or discharge.
The calibration is fixed in the factory and is not variable
The units incorporate a time delay to prevent operation by
car headlights, lightning etc..
They are omni-directional and therefore reference to north
light is not necessary.
The kit consists of 3 parts-
•
Control Unit
•
Socket
•
Base holder/bracket.
IMPORTANT
This unit should be installed to current IEE wiring regulations.
Lowenergie is a registered Trademark
www.lowenergie.com
Lowenergie, Warrington, UK