Download Print this page

Shamir Star Quick Start User Manual

Hide thumbs

Table Of Contents

Quick Start User Guide

Table of Contents

Need help?

Do you have a question about the Star and is the answer not in the manual?

Questions and answers

Summary of Contents for Shamir Star

Page 1 Quick Start User Guide...
Page 2 SUPPLIED PARTS 1 x Right eye pattern plate 1 x Thumb screw 1 x Red plastic insert 1 x Frame jig 1 x Rght eye pattern holding jig 2 x Narrow frame inserts...
Page 3 INITIAL SETUP Unpackage tracer ensuring the machine is seated on a secure, level surface. There are two feet on the rear underside that can optionally be flipped out to alter the angle the tracer sits at. Remove the transport plate by unscrewing the locking thumb screws.
Page 4 TRACING WITH A STAR FULL RIM Choose a frame appropriate for RX ordering and hold it in approximate position in the jaws of the machine. Close the jaws carefully ensuring the bridge center lines up with the vertical line at the back of the jaws. Don’t overdo the pressure or the frame may distort.
Page 5 SUPRA Take the supra jig and insert the sticky pad holder. Stick the right eye lens/ forma to pad so that the lines on the jig are in line with the horizontal line of the forma. Place the jig onto white rubber feet, squeeze barrel and press down until it clicks into place.
Page 6 CALIBRATION Press and hold the green ‘tick’ button in combination with the number 1. This will launch the menu. Press button 1 for calibration followed by the ‘tick’ to confirm. You will then be asked to load the first jig (G00001) which should be assembled by first placing the red plastic insert into the underside so that the pin falls into the hole on the insert.
Page 7 Place the jig onto white rubber feet, squeeze barrel and press until it clicks into place. Next press the green ‘tick’ to confirm that the jig is in place followed by the big green ‘go’ button to start tracing. After a short while the tracer stops tracing, beeps and requests the next jig.
Page 8 DAILY CALIBRATION CHECK It may not always be necessary to perform a full calibration. Usually a simple check will suffice and if it passes the calibration can optionally be skipped. Note that it is still a good idea to calibrate periodically regardless of the check. Press the frame button to tell the machine you intend to do a calibration check.