UBF BonePods-001 Setup

Set up your UBF BonePods-001

1. Charge

⚫
Earphone
When Earphone is charging in the charge box, lights are long-red. When fully
charge, lights turn out.
⚫
Charge case
Charge the UBF BonePods-001 with the included TYPE C charging cable.
Charge case owns two kind of lights. When lights with charging are flash-red,
and fully charging lights are long-red.
When charge case is on discharge, high potential (>3.2V), green light is on; medium
potential (3.2V-2.8V) green light flashes; low potential (< 2.8V) green light is dark.
(Refers to the case where the headset is in the charging case)

2. Pair

Take out the earphone from the charging case and the LED indicator will flash green
and green repeatedly while in discovery. Red and green lights in both ears indicates
that it has not been paired.
(Important Hint: Turning on the charging box switch before opening the charging box
is a prerequisite for the earphone to automatically turn on)

3.Connect

Enable the Bluetooth settings on your device and select "UBF BonePods-001". The
LED indicator will turn green once connected.
Both the left and right earphones can be connected separately and used with other
Bluetooth devices. The earphones are put into the charging case to enter the
charging mode, and the earphones are automatically turned off. If Bluetooth is not
connected within 3 minutes, the headset will automatically shut down.