Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Lanyu E-fair
- Page 1 Please read this manual thoroughly before assembling the model...
- Page 2 Cable ties 30 min epoxy glue Medium CA glue Modelling knife Epoxy glue CA glue...
- Page 3 K i t c o m p o n e n t s Wing support...
- Page 4 mportant Ensure the dihedral of the wings are equal otherwise the model will not fly correctly.
-
Page 5: Servo Installation
Screw the servo's to the plywood servo mount Use the linkage stopper to connect the rod to the servo arm. Servo installation Fix the on/off switch to the left side of the fuselage. - Page 6 R e m o v e t h e f i l m f r o m t h e h i n g e s l o t s Mark the underneath of the stabiliser where it sits on the tail of the fuselage. Mark the stabiliser either side of the fin with a pen R e m o R...
- Page 7 Tail Assembly A s s h o w n i n t h e p i c t u r e , m a r k t h e h o l e s f o r t h e c o n t r o l h o r n s o n t h e r u d d e r a n d e l e v a t o r .
- Page 8 G l u e t h e s t a b i l i z e r a n d v e r t i c a l f i n t o t h e f u s e l a g e w i t h e p o x y g l u e .
- Page 9 M o t o r a n d E S C Install the motor into the nose of the fuselage with screws as shown in the picture. Connect the ESC to the 3 motor wires and the on/off switch. Install the ESC and the battery into the fuselage as shown.
- Page 10 F i n a l a s s e m b l y Wing support Locate the leading edge bamboo dowels into the holes of the front former. Hold the wing securely in place with the 2 wing bolts and wing supports at the rear of the fuselage.
- Page 11 Rudder Adjust the servo throws for the rudder and elevator to achieve the movement shown in the diagram. Elevator T h e p o s i t i o n o f t h e C o f G i s 5 5 m m b a c k f r o m t h e l e a d i n g e d g e a t t h e r o o t e n d o f t h e w i n g n e x t t o t h e f u s e l a g e .
- Page 12 Check the transmitter antenna is correctly extended and check that the battery is connected and fully charged. Do not fly the E-Fair is strong winds Let lipoly batteries cool before recharging and only use a dedicated lipoly battery charger at all times.
- Page 13 This radio control model is not a toy and is not recommended for anyone under 14yrs of age. Prior to assembly read this manual thoroughly. If you are an inexperienced modeller then enlist the help of someone with prior modelling experience.
Need help?
Do you have a question about the E-fair and is the answer not in the manual?
Questions and answers