Useful Hints; Care Of Drive System; Care Of Bearing; Specifications - Systemdek IIX Instruction Manual

7. USEFUL HINTS

7.1 CARE OF DRIVE SYSTEM

Keep the outer (drive) rim of the sub-platter as clean as possible and handle the top stainless steel spindle
only. As required, de-grease the surface of the drive belt, drive pulley and drive hub then apply a little
silicone wax polish to restore belt slip.

7.2 CARE OF BEARING

It is important to know that the bearing used is a substantial piece of engineering which could handle a
much greater load than that required for our turntables and users can dismiss any notion of fatigue, wear or
similar worries during the life of the unit. Some users may, however, want to make and oil change. Use the
syringe and measure .8ml of H.P. 90 oil as required.
This should only be necessary due to transit loss or spillage etc.
Motor: 24 Pose precision synchronous high
torque motor mounted on an anti-vibration
assembly.
Power source: 220--250V 50Hz or 110--125V
60Hz.
Power consumption: 3.3VA (approximately).
Mains switch: Double Pole with noise
suppressor and neon indicator.
Speeds: 33 and 45 R.P.M. (manual change)
Drive System: Precision ground flat rubber belt
SYSTEMDEK LTD., P.O. BOX 9, TROON, SCOTLAND. TEL: (0294) 71251

SPECIFICATIONS

Start-up: 2 seconds to audible stabilisation.
Platter: 3.875lbs (1.73kg)--Glass--10mm
thick.
Record mat: High density lambs wool.
Speed drift: Nil.
Variation under load: 0.15% Ref. 1 hr.
Wow and flutter: 0/09% Din PK weighted.
Rumble: 78/77 Din 'B' weighted.
Hum level: 72dB Din 'B' weighted.
Dimensions: 470mm x 360mm x 140mm.
Weight: 17.6lbs (8kg).