Page 1
Made for first. Built to last. Polaris RZR Rear Bumper Fitment: 2014+ XP1000/XP Turbo/Turbo S...
Page 2
Parts List: Item # Part # Description Qty. Rear Bumper Plastic Pipe Cap 3/8-16 x 3in Bolt 3/8 Nut 3/8 Washer ½-13 x 1 ½ Bolt 1/2 Nylock Nut 1/2 Washer Tools: Tool Qty. Drill w/ 7/16 Metal Bit Rubber Mallet 9/16in Socket 9/16in Wrench 3/4in Socket...
Page 3
Installation: STEP 1: Lay out the supplied parts and hardware as shown on the parts list. Begin the install by gathering the 2 plastic pipe caps and pushing them into the open pipe ends on the bumper. This can be more difficult to install than it would seem.
Page 4
STEP 6: Make sure the bumper is aligned correctly and proceed to completely tighten the two 5/16 bolts on the top of the bumper and then the three 1/2in bolts on the radius plate in that order. Once all the hardware is tightened completely the installation is finished. The final figure 3 product should resemble below.