AwardBlinds Premium Express Cordless 2" Faux Wood Installation Instructions

Premium Express Cordless 2" Faux Wood Installation Instructions
You will need a pencil, tape measure, drill, screwdriver, level and appropriate fasteners.

Step 1: Locate Installation Screws

1 ½" #8 Hex Head Wood Screws (Included)
Alternative fasteners should be used for metal, brick, tile or concrete installations. (Not Included)

Step 2: Mark Blind Location

Position the blind in desired location, making sure that the blind is level when marking. Mark above and at the ends of the blind.

Step 3: Mark the Bracket Locations

End Box Brackets
Outside Mount Installations
Align mounting bracket with blind location marks and mark 2
screw locations.
If center support bracket is required; position the top of the
center support brackets in line with the top of the end brackets.
Locate center supports evenly along the headrail, making sure
that they do not interfere with the blind ladder or working parts.
Check for levelness.

Step 4: Bracket Installation

Outside Mount Installations
Screw brackets into wall as shown

Step 5: Valance Clip Installation

Attach the plastic Valance Clips to the front of the headrail, one approximately 5 ½" from each end. Space any remaining clips evenly between the two.
Use the following # of Center Support Installation Brackets
Less than
35"
0
Center Support
based on the finished Blind Width
35 1/8" – 60 1/8" – 72" Greater than
60" 72 1/8"
1 2
For Inside Mount Installations
Align mounting bracket with blind location marks and mark 2 screw
locations. Depending on the installation location, box brackets can be
attached using the top, back, or side holes.
If center support bracket is required; position the top of the center
support brackets in line with the top of the end brackets. Locate center
supports evenly along the headrail, making sure that they do not
interfere with the blind ladder or working parts.
Inside Mount Installations
Screw brackets into wall as shown
3
92-309951-18