The Things Products The Things Node Getting Started

For installation & set up please visit
https:/ /ttn.fyi/activate
GETTING STARTED WITH
EN
THE THINGS NODE
For full installation & setup please visit
https:/ /ttn.fyi/activate.
1. Unscrew the enclosure with a screwdriver.
2. Mount the 3 AAA Alkaline 1.5V batteries.
3. Connect a micro USB cable to an USB port of your
computer and to the micro USB connector on the
Things Node.
4. Continue with the steps as described in the
illustrated quick start guide for the Things Node
found on https:/ /ttn.fyi/activate.

INSTRUCTIONS FOR SAFE USE

The Things Node shall only be powered by 3 AAA
Alkaline 1.5V batteries or via micro USB.
The connection of incompatible devices to the Things
Node (f.e. via the micro USB connector) may affect
compliance or result in damage to the unit and
invalidate the warranty.
The Things Node has one of the following modules on
board with the following frequency and output
power;
Frequency Maximum TX
Range Range
LoRaWAN
902 to 928 MHz 27 dBm
915 MHz