Advertisement
Quick Links
Advertisement
Summary of Contents for multi edge ADVANCE
- Page 1 ADVANCE Installation instructions...
- Page 2 Profile Profile with folded top and bottom edges into which the connector strips are inserted Connector strips Each fixing stake is attached to the profile using two connector strips. The connector strips are also used to connect the profiles together Fixing stake The fixing stake is inserted in the soil to give the edging stability Corner piece (optional)
-
Page 3: Installation Instructions
• You can clean the edging profiles using a soft brush. • There is no layer of rust on Multi-Edge ADVANCE in CORTEN at the time of delivery. The layer of rust will develop over time depending on the weather. - Page 4 Before the profiles are installed in the soil, fit 2 connector strips at 60-70 cm intervals for attaching the fixing stakes 60-70cm to the profile. Do this by pushing a connector strips underneath the top and bottom edge of the profile.
- Page 5 Place the profile loosely in the channel dug. Bend the profile by hand to create a curved contour. Bend the profile around a solid object (e.g. the edge of a workbench) to create an angle. Or use the optional corner pieces (step 6). Cut off any excess length using a grinder or metal saw.
- Page 6 For extra neat 90° angles, use the optional corner pieces. Connect the corner pieces to the profiles using the connector strips. Press the connector strips against the profile and push the fixing stake through the openings in the connector strips, leaving half of the fixing stake protruding above the edging profile.
- Page 7 Gently tap all the fixing stakes into the soil with a hammer until the top comes into contact with the connector strips. Close the seams at the ends of the profiles and corner pieces by pressing the ends together and then gently push the fixing stake into the soil.
Need help?
Do you have a question about the ADVANCE and is the answer not in the manual?
Questions and answers