Summary of Contents for Flying Eye DJI MATRICE 300 RTK
- Page 1 Parachute system and Circuit breaker DJI MATRICE 300 RTK Before using the parachute system, please read this manual carefully.
- Page 2 USER MANUAL PRESENTATION Flying Eye has been your partner specialised in drone technology since 2009. We have been developing parachute systems since the drone regulations appeared in 2012. It’s a pyrotechnic sys- tem based on aviation technology, making it the most efficient and lightest system on the market.
- Page 3 USER MANUAL WARNINGS Flying Eye may suspend the guarantee and disclaim all liability to any person who fails to comply with the basic safety instructions set out below. Flying Eye declines all responsibility for damage or injuries directly or indirectly related to the use pyrotechnic cartridges that do not conform to the safety require- ments and standards.
-
Page 4: Technical Description
Assembly and disassembly of the system is feasible by the customer. The system does not alter the integrity of the DJI MATRICE 300 RTK. The DJI manufacturer’s guarantee is retained. Fits in the original case of the MATRICE 300 RTK. - Page 5 USER MANUAL CONTENT : • 2 parachute containers • 1 insert module left • 1 right-hand spacer module • 1 cradle (landing gear support) • 2 load plugs • 2 pyrotechnic charges • 1 remote control • 1 micro USB cable •...
- Page 6 USER MANUAL PARACHUTE REMOTE CONTROL Radio control charge level : To find out the charge level, press the button once. «POWER», indicator lights appear. Switching on : To switch on the parachute radio control, press and hold the «POWER» button. The left-hand light will light up green, the first right-hand light will light up red and will go out when the radio control is paired with the drone’s internal receiver.
- Page 7 USER MANUAL Lighted Flashing light FLYSAFE-M3 Version 1.00 12/11/2020 Hardware version 1.04...
-
Page 8: Mode Of Operation
USER MANUAL INSTALLATION OF PARACHUTE RADIO CONTROL MODE OF OPERATION Open the cover of dongle 4G. Unscrew the two ring fastening screws (red arrow) Remove the ring and position it on the parachute remote control, then screw it on. Position the parachute remote control on the SmartController radio remote control: Attach the ring and aim Close the cover of dongle 4G. -
Page 9: Installation
USER MANUAL INSTALLATION Installation of the parachute cradle : In order to be able to position the parachutes on the drone you must: Unscrew the two landing gear supports Position the cradle in place and place the cradle under the drone. Fix it with the 4 screws on each side (USB connector towards the front). - Page 10 USER MANUAL Installation of the circuit breaker modules : To place the circuit-breaker modules on each side in the battery slots, insert them from the rear by sliding them forwards. Slide the modules all the way to the front as far as they will go to ensure a good connection on the connec- tor.
-
Page 11: Functional Test
USER MANUAL FUNCTIONAL TEST Before each flight, you must check all the components of the system and verify its integrity. If an anomaly is found, do not flight and contact your retailer. Functionality test on the ground: • Make sure that the entire drone system is powered down. Battery TB60 disengaged. •... -
Page 12: Annual Maintenance
USER MANUAL MAINTENANCE ANNUAL MAINTENANCE Change of pyrotechnic charges. Ventilation of the canopy for 24 hours, inspection of the canopy, lines and folding. Annual mainte- nance of the canopy is essential for optimal system operation. STORAGE AND GUARANTEE SPECIFIC INTERVIEW: You must dry the canopy immediately after any contact with moisture or water to avoid any deterioration. - Page 13 Contact us : Flying Eye 80 route des lucioles Bat. I14 06560 SOPHIA ANTIPOLIS Mail : info@flyingeye.fr Tel : 09 72 62 78 50...