Summary of Contents for K-Line Irrigation G-Set
- Page 1 K-Line™ G-Set™ Irrigation Solid Set Irrigation for pasture May 2017 K-Line Irrigation NA 4270 Hollywood Road St. Joseph, MI 49085 Toll Free 866-665-5463 Local 269-429-3000 Email info@k-linena.com www.k-linena.com...
- Page 2 Contents G-Set is a solid set fixed system that minimizes “labor” for the day to day operation of irrigation. G-Set Sub-Main and “T” Installation It is suitable for all land areas, and is not restricted by the shape, terrain, size or topography.
- Page 3 “T”s attached approximatley 3 feet adjacent to the predetermined G-Set locations. The G-Set locations are designed around layout coverage and terrain. A 40mm feed line will extend from the “T” to the G-Set side entry. The main and sub-main pipes are to be installed (trenched in) below maximum frost level.
- Page 4 Tighten firmly with one pipe wrench holding the internal pipe assembly. Lay the G-Set shell on it’s side and insert the assembly into the shell. Line up the 11” nipple portion of the valve assembly into the 2” hole in the side and very bottom of the shell.
- Page 5 This hole should be approximately 36” from the 2” PVC sub-main “T”. Compact the hole opposite the connection side so the G-Set fits tightly into the hole. (You will need room on the connection side to attach your 14”...
- Page 6 K-Line™ G-Set™ Irrigation Getting Started Programming the Controller G-Set Controller Features Meaning of Controller icons • Up to two operations per day NOTE: Quick presses of the • Easy installation and programming MODE button turns the controller on or off.
- Page 7 K-Line™ G-Set™ Irrigation Trouble Shooting Continue Setting the Irrigation duration and START Times 5. Use the and to set the START 1 minutes. 6. Press SET to continue 7 Use the to set the START 1 hour 8. Press SET to continue 9.
- Page 8 Battery controller (C1013) install tools Phillips head screwdriver 1 1/4” hole saw – for the attachment of the socket to the lid of the G-Set Drill Programming of the controller should be completed before mounting Connect the controller to the bracket. Connect...
- Page 9 K-Line™ G-Set™ Solar Panel Installation Drill a 1 1/4” hole at the back of the rectangular updent to mount the solar panel. Ensure that the solar panel faces the best solar collection direction. Generally this will be southerly. The best outcome generally is a bit to the West of South, or East of South.
- Page 10 K-Line™ G-Set™ Solenoid Wiring Assembly Using the included wire nuts, you are able to connect the solenoid (latch) coil to the controller. Installing the Connectors 1. Strip wires ½" 2. Align frayed strands or conductors 3. Do not pre-twist. Place stripped wires together with ends even.
- Page 11 Bottom Guard Plug Install the stockguard on the shell with the four remaining screws and the unit is ready to use. NOTE: If using a battery drill to install the screws, avoid stripping the plastic shell of the G-set by not over-tightening.
- Page 12 May 2017 K-Line Irrigation NA 4270 Hollywood Road St. Joseph, MI 49085 Toll Free 866-665-5463 Email info@k-linena.com www.k-linena.com...