Related Manuals for ALEXAPURE Home
Summary of Contents for ALEXAPURE Home
- Page 1 Alexapure Home ® Under Counter Water Filtration System Passionately Innovated. Pioneered for Perfection.™ P a g e...
- Page 2 Please keep this Owner’s Manual for future reference. TABLE OF CONTENTS 1. Installation: Preparation page 3 Feed water connection page 4 Filter housing assembly page 5 Connecting the whole system page 6 2. Maintenance: Filter change schedule & Instructions page 7 Warranty page 8 P a g e...
- Page 3 Please take the system and all components out of the box. Inspect the system and all the connection fittings carefully. If any part of the system is damaged please do not start the installation process. Contact your Alexapure distributor for assistance. Recommended tools list: •...
- Page 4 • Protect filter housing from freezing. • Ensure O-rings are properly seated in their grooves. • The Alexapure Home is intended for cold water use only. • Installation needs to comply with state and local laws and regulations. Components included with your system: Make sure you have all these parts before starting installation.
- Page 5 Parts Included: 3. System head 4. 2 filters and 2 filter housings 5. 1 Feed water adaptor 3/8” with needle valve kit 6. 2 blue colored tubing ¼” 7. 1 Metal Wrench 8. 1 Green Wrench for opening housing Fitting Types: There are 2 types of fittings provided for connecting the system 1.
- Page 6 THERE ARE TWO STEPS TO INSTALLING THE SYSTEM: Part I. Assemble the filters and housing onto the main system Part II. Installing the system STEP I. ASSEMBLE THE FILTERS AND HOUSING AND ATTACH TO THE MAIN SYSTEM Remove plastic/paper wrappings on the 2 filters, put them into the 2 housings, and assemble to housings onto the main system as follows: 1) See Fig.
- Page 7 Step 1: Feed Water Connection The system can only be connected to the COLD water supply. 1. Shut off water supply. 2. Locate the COLD water supply valve under the kitchen sink. Turn off the incoming cold water – turn the handle clockwise. 3.
-
Page 8: Filter Change Instructions
1. Ensure filters properly installed and casing attached. 2. Close faucet. 3. Slowly turn on the water supply, check for leaks. 4. Turn cold water faucet on slowly, run water 5 – 10 minutes prior to use. *To shorten tubing if desired, cut tube ends square and straight if necessary, avoid sharp turns that can cause tubing to flex and deform. - Page 9 Alexapure Home. Alexapure, LLC warrants your HOME Water Filtration System for one year from the date of purchase (except replacement filters) against all defects in materials and workmanship, when used in compliance with the directions set forth in this owner’s manual.
Need help?
Do you have a question about the Home and is the answer not in the manual?
Questions and answers
How to clean minerals out of the topp & bottom sections.
To clean minerals from the top and bottom sections of the Alexapure Home:
- For the exterior chambers: Wipe with a soft cloth to remove dust.
- For the interior: Rinse with cool, clean water before first use.
- For the filter exterior: If mineral buildup occurs, carefully remove the filter from the upper chamber, scrub the exterior with a scour pad and clean water (no soap), rinse thoroughly, and replace it.
This helps maintain cleanliness without affecting filtration performance.
This answer is automatically generated