Lambario LT60-01010 Instruction

USER MANUAL / MANUAL PËRDORIMI
BEDIENUNGSANLEITUNG / ПAСПOPТ NЗДEПNя
Udhëzimet e përdorimit
AL
INPUT
MODEL NO POWER (W) IP
VOLTAGE(VAC)
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
LT- -  IP
www.lambario.com
WORK
WORK
CCT
TEMPERATURE( C ̊ ) HUMIDITY(RH)
- C/+ C
< K
- C/+ C
< K
- C/+ C < K
- C/+ C < K
- C/+ C < K
- C/+ C < K
- C/+ C
< K
- C/+ C
< K
- C/+ C
< K
- C/+ C < K

LED FLOODLIGHT INSTRUCTION

Specifications and Technical Data sheet：
Luminaire Category: LED Floodlight
Input voltage: AC230V 50HZ
Ambient Temperature: -40℃<TA<50℃

WARNING:

1.ENSURE ELECTRICITY IS SWITCHED OFF BEFORE INSTALL .
2.Please read through all following instructions before installing the unit.
3.User should prepare necessary accessories and spare parts (not provided) including junction box .
4.The Floodlight must be earthed.
5.Method of aachment of the cable or cord such that any replacement can only be
made by the manufacturer, his service agent or similarly qualified person.

MOUNTING

1. Do not mount a surface prone to vibrations.
2. Remove the screw which is for mounting the bracket of the fixture. Remove the bracket.(see fig.1)
3. Mark the hole position for fixing bracket onto the wall. Drill the wall at the marked positions
(screw not supplied). (see fig.2)
4. Screw the fixing bracket to the wall with suitable screw(see fig.3)
5. Mount the bracket back to the fixture. Adjust the floodlight to desired position and tighten the screw
of fixing bracket(see fig.4)
6. Connect your mains cable(H05RN-F3G1.0mm2 Recommended) with the input lead of our product
through the waterproof junction box. Note the Line(-) of the lead. (see fig.5) (Need to use the junction
box of IP65 or above, ensure to tighten the waterproof screw)
7. Open the power to make sure if the product can be lighten. Adjust the irradiation angle according
to the condition of usage.(see fig.6)
Please operate it strictly according to the instruction, otherwise the consequence is proud.
Please don't open our products by yourself, it may causes water leakage.The power of final interpretation belong to the manufacturer.
www.lambario.com