Subscribe to Our Youtube Channel
Summary of Contents for T-MAX ATW 6000
- Page 1 FITTING INSTRUCTIONS CONTENTS 12V 7305100 Non-Radio Control (Wire Rope) 12V 7305101 Radio Control ( Wire Rope) 12V 7305110 Non-Radio Control (Synthetic Rope) 12V 7305111 Radio Control (Synthetic Rope) M730904A...
-
Page 2: General Safety Precautions
INTRODUCTION Thanks for your interesting in T-MAX Products, especially the ATW6000, and we sincerely hope that it will satisfy you. We not only have the professional capability to design winches but also with comprehensive after-sale service. Please do not hesitate to contact us for any further messages or suggestions. - Page 3 2. ATW6000 is designed primarily for intermittent duty general use. This winch is not designed to be used in industrial or hoisting applications. ATW6000 does not warrant it to be suitable for such use. T-MAX manufactures a separate line of winches for industrial/commercial use.
- Page 4 6000LBS WINCH PARTS LIST T-MAX UTV SERIES...
- Page 5 Roller Fairlead(match to Wire Rope) 34 7241100.7 Wire Rope 35 9163151 Synthetic Rope Aluminum Fairlead(match to Synthetic 36 7309200.7-2 Rope) 37 RU104206 Clevis Hook Short Black Cable (25mm2 x 5cm) 38 7241100.6-1 (wrapped by Black Thermoplastics Pipes) T-MAX UTV SERIES...
- Page 6 R a d i o S e n d e r & 7241100.6.5-2 Receiver 7241100.6.1 GB/T93 6 Washer GB/T41 M6 7241100.6.5-3 Mounting Plate G B / T 7 0 . 2 Bolt M5×10 10 7241100.6.5-4 Control Box soleplate T-MAX UTV SERIES...
-
Page 7: Features And Specifications
Overall Dimensions: (LxWxH) 15.08”x5.12”x7.32”(383mm x 130mm x186mm) P/N: 7305111(Radio Control) P/N: 7305110(Non-Radio Control) Rated Line Pull: 6000 lbs (2720kgs) Single-line Motor: 12V , 1.3HP (Series Wound) Control: Radio Control / Remote Control Gear Ratio: 148:1 Clutch: Turn 90°By Hand wheel T-MAX UTV SERIES... - Page 8 Normally precautions will extend the life of your motor. Keep the duration of pulls as short as possible. If the end of the motor becomes uncomfortable hot to touch, stop winching and allow the motor to cool down. T-MAX UTV SERIES...
- Page 9 5. Inspect the wire rope and equipment frequently. A frayed wire rope with broken strands should be replaced immediately. Always replace wire rope with T-MAX’s identical replacement part. Periodically check the winch installation to ensure that all bolts are tight.
- Page 10 This can jamb the wire rope in the winch, causing damage to the winch or the wire rope. 13. Always operate the winch with an unobstructed view of the winching T-MAX UTV SERIES...
-
Page 11: Installation
The safety mounting location must be plane and the thickness must be at least 0.31inch (8mm). Do dill four holes which diameter is 10.5mm and position is 152mmX110mm. (see Figure 7) T-MAX UTV SERIES... - Page 12 Step(1)) and the mounting plate from the bottom up. Note: To use the mounting bolts (M10x35mm)and washer 0.4inch(10mm) which are supplied by T-MAX. Step (3) Turn the clutch handle to the direction of “out”; Let the wire rope through the roller fairlead;...
-
Page 13: Installation Drawings
Discharge two bolt which is at the side of the control box,and then to screw the two bolt through the hole of the mounting palte and fix the control box tightly with a wrench for Allen screws. T-MAX UTV SERIES... - Page 14 1. Be sure battery cables are not drawn taught across any surfaces, which could possible damage them. 2. Be sure battery cables are not drawn taught across any surfaces, where is too hot or tight. 3. Clean all connections especially in remote control switch and receptacle. T-MAX UTV SERIES...
- Page 15 Figure of the Electric Theory [1] [2] is optional T-MAX UTV SERIES...
- Page 16 5. To engage the clutch, turn on the remote control as “IN” position. The winch is now ready for pulling. MAINTENANCE Periodically check tightness of mounting bolts and electrical connections. Clear any dirt or corrosion that may have accumulated on the electrical connections. T-MAX UTV SERIES...
- Page 17 NOTE: Repair should be done by Authorize T-MAX Repair Centers ONLY. Do not attempt to disassemble the gear box. Disassembly will avoid warranty. The safety precautions and instructions discussed in this manual can’t cover all possible conditions and situations that may occur. It must...
Need help?
Do you have a question about the ATW 6000 and is the answer not in the manual?
Questions and answers